摘要
介绍了TD处理工艺流程和相关工艺参数控制、TD处理后焊接部位不形成膜的解决措施,通过6种焊条试验后的数据(膜厚、硬度、缺陷等),筛选出2种最合适的焊条以及TD处理后使用维护过程中的相关注意事项等,为厂家提供一定的参考。
The TD control process and related parameters were presented, and the solutionto form a film at the welding areas after TD treatment was put forward. Through the testdata from 6 kinds of covered electrode （film thickness, hardness, defect etc.）, two kinds ofthe most suitable were screened. The related matters needing attention in the usage andmaintenance process after TD treatment were summarized, which could provide some refer-ence for the manufacturers.
作者
叶立渊
赵树林
YE Li-yuan, ZHAO Shu-lin(Quality and Manufacturing Engineering Center, Yog0mo Automobile Manufacturing Limited Company, Wuxi, Jiangsu 214000, Chin)
出处
《模具工业》
2018年第3期65-68,共4页
Die & Mould Industry
关键词
TD处理
高强度钢板
冲压成形
焊接
变形
TD treatment
high strength steel plate
stamping
welding
deformation
