摘要
为了保证电力载波通信网络的运行安全,以单片机及FPGA为硬件支持,设计基于单片机及FPGA的电力载波通信异常信号监测系统;根据电力载波通信网络的异常原因,设置异常信号特征作为判据;在建立的电力载波通信网络模型下,利用装设的信号采集设备、单片机以及FPGA元件,采集并处理电力载波通信信号;通过实时通信信号的特征提取与匹配,判定当前信号的异常状态,计算得出通信异常信号量和信号异常类型,最终以可视化的形式输出电力载波通信异常信号的监测结果;通过系统测试得出结论:与传统通信异常信号监测系统对比,优化设计系统的通信异常信号量的监测误差降低了1.37 dBm,且通信异常信号类型的误检率为14%。
In order to ensure the safety of power carrier communication network,and it is supported by micro-controller and FPGA as the hardware,a power carrier communication abnormal signal monitoring system based on single chip microcomputer and FPGA is designed.According to the abnormal cause of power carrier communication network,the abnormal signal characteristics are set as the criterion.Under the established power carrier communication network model,the signal acquisition equipment,microcontroller unit(MCU)and FPGA components are installed to collect and process the power carrier communication signals.Through feature extraction and matching of real-time communication signal,the abnormal state of the current signal is determined,and the abnormal signal semaphore and type of signal are calculated.Finally,the monitoring results of abnormal signal in the power carrier communication are output in a visual form.Through the system test,it is concluded that compared with traditional communication abnormal signal monitoring systems,the monitoring error of the communication abnormal signal quantity in the optimized design system is reduced by 1.37 dBm,and the error detection rate of communication abnormal signal type is 14%.
作者
张伟
ZHANG Wei(School of Artificial Intelligence,Xi'an Aeronautical Polytechnic Institute,Xi'an 710089,China)
出处
《计算机测量与控制》
2023年第12期8-13,20,共7页
Computer Measurement &Control
关键词
单片机
现场可编程门阵列
电力载波通信
通信异常
通信信号监测
micro-controller
FPGA
power carrier communication
abnormal communication
communication signal monitoring
