摘要
预埋件设计是建筑幕墙设计中至关重要的环节。文中对比分析了GB 50010-2010《混凝土结构设计规范》、JGJ 102-2003《玻璃幕墙工程技术规范》以及16G362《钢筋混凝土结构预埋件》中有关预埋件设计方法,并给出了使用建议。除了常规板式预埋件,幕墙工程还会遇到如双向受力埋件、受扭埋件等规范中无计算公式的埋件类型,建议了相应的设计方法,为设计人员提供借鉴和参考。
Design of embedded parts is one of the most important steps for curtain wall design.In this paper,the design methods of embedded parts in GB 50010-2010,JGJ 102-2003 and 16G362 were compared and the design method was suggested.In addition to conventional plate embedded parts,curtain wall engineering also needs to use embedded parts without calculation formula in norms shuch as bidirectional loadingand torsion parts.This paper suggests the corresponding design methods,and provides reference for curtain wall designers.
作者
李腾
李滇
梁云东
王超
刘发令
LI Teng;LI Dian;LIANG Yundong;WANG Chao;LIU Faling(CABR Technology Co.,Ltd.,Beijing 100013,China;National Engineering Research Center of Building Technology,Beijing 100013,China)
出处
《低温建筑技术》
2021年第1期81-84,共4页
Low Temperature Architecture Technology
关键词
幕墙
预埋件
锚筋
Curtain wall
Embedded parts
Anchored bar
