摘要
为了大幅提高线阵CCD的测量精度,提出了一种全新的CCD使用方法。该方法是将N个像元间距为H的线阵CCD器件并排组合在一起,并沿像元线性分布方向以距离为H/N依次均匀错开排列。多个线阵CCD的感光电信号经多通道模数同步采集,保存到存储器中指定位置。然后,通过对所有CCD测量数据的分析计算来获得精确的测量值。分别采用单CCD和双CCD错排对长为30mm,直径为5.000 mm8、.000 mm、12.000 mm的三个标准杆件的直径进行了测量。结果表明,双CCD错排可获得两倍于单CCD的测量精度。该方法可从理论上彻底打破CCD像元间距的限制,并使线阵CCD的测量精度大幅度地提高。
For higher measurement accuracy of linear charge coupled device （CCD）, a new memou of using CCD was proposed. Several linear CCDs were fit together, and staggered by the distance of H/N, H was space between pixels, N was CCD amount. The photo electric signals were collected in-phase by multicenter A/D, and saved in memorizer. Then accurate value was obtained through analyzing all these data. Diameters of 5. 000 mm, 8. 000 mm and 12. 000 mm of three standard poles were measured by single CCD and two staggered CCD with 30 mm stagger long. The result showed that accuracy using two staggered CCD was twice as high as that using single CCD. The method could avoid space between pixels astriction theoretically, so higher measurement accuracy was gained.
出处
《光学学报》
EI
CAS
CSCD
北大核心
2005年第11期1488-1492,共5页
Acta Optica Sinica
基金
国家自然科学基金(90410013)资助课题
关键词
测量
CCD像素错排
非接触式测量
像元间距
measurement
CCD image stagger
noncontacting measurement
image space-between
