摘要
目的研究温度对B_(4)C涂层氧化防护性能和防护机制的影响,得出B_(4)C涂层最佳氧化防护温度范围,以及B_(4)C涂层在不同温度的氧化防护机制演变。方法以石墨为基体,采用放电等离子烧结法在石墨表面制备B_(4)C涂层,通过不同恒温氧化试验(800、1000、1200、1400℃)和室温至1400℃宽温域动态氧化试验来测试其氧化防护性能,并通过X射线衍射(XRD)、扫描电子显微镜(SEM)和能谱仪(EDS)对B_(4)C涂层石墨试样氧化前后的物相组成、微观形貌、氧扩散等进行分析。结果B_(4)C涂层氧化后可生成B2O3玻璃膜,在800、1000、1200、1400℃恒温氧化的防护效率分别为98.43%、98.61%、94.4%和92.8%,在室温至1400℃宽温域动态氧化的防护效率为93.1%。B_(4)C涂层在800℃以下主要依赖结构阻氧,800至900℃由结构阻氧向惰化阻氧转变,900℃以上主要依赖惰化阻氧。1100℃以上,随温度升高B2O3玻璃膜的挥发加剧,B_(4)C涂层惰化阻氧能力减弱。结论B_(4)C涂层的氧化防护效率随温度上升先增大后减小,结构阻氧机制逐渐降低,惰化阻氧机制先升高后降低。B_(4)C涂层在800至1100℃具有良好的氧化防护性能。
The oxidation of B_(4)C coatings can generate a B2O3 glass film,which is a good oxidation protection material for carbon materials.The effect of temperature on the oxidation protection performance and mechanism of B_(4)C coatings was studied,and the optimal oxidation protection temperature range of B_(4)C coatings and the evolution of oxidation protection mechanism of B_(4)C coatings at different temperature were obtained.In this paper,a B_(4)C coating was prepared on a graphite surface by spark plasma sintering(SPS),and its oxidation behavior and oxidation protection mechanism were investigated by isothermal oxidation at different temperature(800,1000,1200,1400℃)and dynamic oxidation in a wide temperature range from room temperature to 1400℃.The phase composition,micro-morphology and oxygen diffusion of B_(4)C coated graphite samples before and after oxidation were analyzed with an X-ray diffraction(XRD),a scanning electron microscopy(SEM)and an energy dispersive spectroscopy(EDS).The results showed that the B_(4)C coating was oxidized at 800,1000,1200 and 1400℃for 100 min,the oxidation protection efficiency was 98.43%,98.61%,94.4%and 92.8%,respectively.When the B_(4)C coating was oxidized at 800℃,the rate of coating oxidation and glass film formation were slow,so oxygen diffused to the interior of the coating and the substrate,resulting in rapid reduction of oxidation protection efficiency at the initial stage of oxidation;when continuous B2O3 glass was formed,the pores in the coating were reduced,and the protective efficiency of the coating rebounded;after oxidation for 60 min,the oxidation protection efficiency was basically stable.The B_(4)C coating had better protection effect at the initial stage of oxidation at 1000℃than other temperature;with the duration of oxidation,its protection efficiency slowly decreased,and the oxidation protection efficiency was basically stable after oxidation for 60 min.The protection efficiency only decreased by 1.39%after oxidation for 100 min at 1000℃.When B_(4)C
作者
胡凯飞
王佩佩
孙万昌
侯兆琪
易大伟
罗欢
任宣儒
HU Kaifei;WANG Peipei;SUN Wanchang;HOU Zhaoqi;YI Dawei;LUO Huan;REN Xuanru(College of Materials Science and Engineering,Xi'an University of Science&Technology,Xi'an 710054,China;Carbon Matrix Composites Research Institute,Henan Academy of Sciences,Zhengzhou 450046,China)
出处
《表面技术》
EI
CAS
CSCD
北大核心
2024年第4期89-97,共9页
Surface Technology
基金
国家自然科学基金(52272055,51972338,52261135546)
陕西省自然科学基金(2023-JC-QN-0563,2022JQ-355)
陕西省教育厅自然科学专项(22JK0458)
西安科技大学优秀青年科技基金。
关键词
涂层
石墨
碳化硼(B_(4)C)
玻璃膜
氧化防护
阻氧机制
coating
graphite
boron carbide(B_(4)C)
glass film
oxidation protection
oxygen-blocking mechanism
