摘要
通过对芳纶浆粕表面进行简便的环境友好的热处理,探究少量芳纶浆粕作为增强体加入到氟醚橡胶/炭黑基体中对复合材料耐疲劳性能的影响。载荷控制的拉-拉疲劳实验结果表明,经过热处理后,提高了界面粘接,芳纶浆粕增强的氟醚橡胶复合材料疲劳寿命的改善十分显著,循环次数高达80797次,未经热处理的芳纶浆粕填充的复合材料循环次数达42358次,而未填充芳纶浆粕的复合材料循环次数仅为2556次。少量芳纶浆粕的加入,对氟醚橡胶耐低温性能和硫化行为无明显影响。通过对比3种复合材料的损耗因子,发现使用热处理芳纶浆粕填充的复合材料损耗因子较小,说明该复合材料具有更优的承载能力以及阻尼特性。
The effect of the incorporation of a small amount of aramid pulp(AP)as a reinforcement into a fluoroether rubber/carbon black(FER/CB)matrix on the fatigue resistance of the composites was investigated by a simple and environmentally friendly heat treatment of the aramid pulp surface.The results of load-controlled tension-tension fatigue tests showed that the heat treatment improved the interfacial bonding,and the fatigue life of the AP-reinforced fluoroether rubber composites improved significantly,with a fatigue cycle number as high as 80797,and the cycle number of the composites filled with non-heat-treated AP amounted to 42358,while that of the composites unfilled with AP was only 2556.The addition of a small amount of AP had no significant effect on the low-temperature resistance and vulcanization behavior of the FER.By comparing the loss factors of the three composites,it was found that the loss factor of the composite filled with heat-treated AP was lower,indicating that the composite had better load-carrying capacity as well as damping characteristics.
作者
梁久明
罗筑
张豪
钟金成
王星宇
Liang Jiuming;Luo Zhu;Zhang Hao;Zhong Jincheng;Wang Xingyu(College of Materials&Metallurgy,Guizhou University,Guiyang 550025;Guizhou Rubber Composites Engineering Laboratory,Guiyang 550025)
出处
《化工新型材料》
CAS
CSCD
北大核心
2023年第12期108-111,117,共5页
New Chemical Materials
基金
贵州省科技支撑计划项目(黔科合支撑[2021]一般321)。
关键词
芳纶浆粕
热处理
氟醚橡胶
疲劳寿命
aramid pulp
heat treatment
fluoroether rubber
fatigue life
