摘要
介绍了无取向电工钢连续退火涂层机组纯水高效利用技术。通过前后清洗段各循环槽和循环罐内纯水逐级溢流回收利用,并在末端利用前清洗高压喷淋罐内的纯水,进一步配置一定浓度的碱液,同时对后清洗向前清洗的输送泵的启动及停机条件、连锁条件进行调整优化,可做到后清洗纯水无溢流,完全输送到前清洗段,达到用水平衡,机组纯水利用率得到大幅提高。
The technology of high efficiency utilization of pure water in continuous annealing coating unit of non-oriented electrical steel was introduced in this paper.Through the gradual overflow recovery and utilization of pure water in each circulating tank and circulating tank in the pre-cleaning and post-cleaning section,and further using the pure water,which was in the high pressure spray tank before its utilization at the end,to configure a certain concentration of alkali,and meanwhile adjusting and optimizing the start-up and shut-down conditions of the tranfer pump from post-cleaning to pre-cleaning and the interlocking conditions,the post-cleaning pure water can be of no overflow and completely transport to the front cleaning section,achieving water balance,and greatly improving the rate of pure water utilization.
作者
段建高
刘金学
何家峰
DUAN Jiangao;LIU Jinxue;HE Jiafeng(Silicon Steel Department of Baoshan Iron and Steel Co.,Ltd,Shanghai 200431,China)
出处
《电工钢》
2020年第5期34-37,共4页
ELECTRICAL STEEL
关键词
无取向电工钢
退火
纯水
高效利用
non-oriented electrical steel
annealing
pure water
high efficiency utilization
