摘要
介绍了镁合金摩擦生热渐进成形原理,并研究了在工具头行进速度为1000 mm·min^-1下,工具头主轴转速(1000~6000 r·min^-1)、轴向进给量(0. 5~3 mm)、成形角度、工具头半径、环境温度对厚度为2 mm的镁合金板料圆锥台零件成形性的影响。实验结果表明:随着主轴转速的增加,零件表面质量先升高后降低;零件表面质量随着轴向进给量的增加而降低;在成形极限角内,零件表面质量随着成形角度增加而提高;零件表面质量随着工具头半径增加先升高后降低;加工时环境温度对成形结果有影响。通过摩擦生热的方式对AZ31B镁合金板料加热,板料温度会随着主轴转速、轴向进给量和工具头半径递增而增加,成形角度对板料温度的影响不大。
The principle of frictional heat incremental forming for magnesium alloy was introduced,and the influences of spindle rotating speed of tool head(1000-6000 r·min^-1),axial feeding amount( 0. 5-3 mm),forming angle,tool head radius and ambient temperature on the formability of cone table part for magnesium alloy sheet with thickness of 2 mm were studied under the tool head moving speed of 1000 mm·min^-1. Experimental results show with the increasing of the spindle rotating speed,the surface quality of parts rises first and then decreases,and the surface quality of parts decreases with the increasing of the axial feeding amount. Within the forming limit angle,the surface quality of parts increases with the increasing of the forming angle,and with the increasing of the tool head radius,the surface quality of parts increases first and then decreases. However,the ambient temperature during processing has an influence on the forming result. Furthermore,when the AZ31B magnesium alloy sheet is heated by frictional heat generation,the temperature of sheet increases with the increasings of the spindle rotating speed,axial feeding amount and tool head radius,and the forming angle has little effect on the temperature of sheet.
作者
王嘉豪
周六如
姜旭
胡诗尧
Wang Jiahao;Zhou Liuru;Jiang Xu;Hu Shiyao(College of Mechanical and Electrical Engineering,Nanchang University,Nanchang 330031,China)
出处
《锻压技术》
CAS
CSCD
北大核心
2020年第1期47-54,共8页
Forging & Stamping Technology
基金
国家自然科学基金资助项目(51465038)
南昌大学2019年科研训练项目(镁合金摩擦热渐进成形变形特征和成形能力研究
镁合金摩擦热渐进成形表面粗糙度的实验研究和优化)
关键词
渐进成形
主轴转速
轴向进给量
表面质量
镁合金
incremental forming
spindle rotating speed
axial feeding amount
surface quality
magnesium alloy
