摘要
采用金相显微镜、扫描电镜观察和力学性能测试方法,研究了形变和热处理对微合金化Zn合金的组织与性能的影响。结果表明,随着变形量的增加,Zn-2.1Cu-0.06Ti合金的显微硬度呈现先增加而后减小的趋势,当冷变形量达到70%时显微硬度取得最大值;随着Cu含量的上升,导致Zn-Cu-Ti合金的显微硬度下降的温度也逐渐升高;一定范围内Cu的添加可以提高纯Zn的显微硬度和抗拉强度,Ti元素含量的增加可以改善Zn-Cu-Ti合金的韧性。
Through hardness test, optical microscope, scanning electron microscope and mechanical prop- erties test, influence of deformation and heat treatment on microstructure and properties of micro allo- ying of Zn alloy were investigated. The results show that, with the increase of deformation rate, micro- hardness of Zn-2.1Cu-0.06Ti alloy is increasesd firstly and then decreased. When the cold deformation rate reaches 70% microhardness has a maximum value, with the increase of Cu element content, the temperature resulting in the descrease of micro-hardness of Zn-Cu-Ti alloy is increased gradually. The Cu element within a certain range of addition can improve the micro-hardness and tensile strength of pure Zn, and increase of Ti element can improve the toughness of the alloy.
出处
《特种铸造及有色合金》
CAS
CSCD
北大核心
2015年第6期669-672,共4页
Special Casting & Nonferrous Alloys
基金
四川省大学生创新创业训练计划项目
四川农业大学创新性实验项目(1310626090)
四川农业大学创新训练项目(040606693)
关键词
形变
热处理
锌合金
组织
性能
Deformation, Heat Ttreatment, Zinc Alloy, Microstructure, Property
