摘要
设计一套以音圈电机为驱动电机,柔性铰链为支承元件,碟形弹簧为减震机构的微进给机构.柔性铰链采用双平行四杆机构的结构形式,计算了柔性铰链在音圈电机峰值推力作用下的最大输出位移和最大应力值.通过有限元分析柔性铰链在不同推力作用下的应力、应变图,发现在音圈电机最大推力800 N作用下,柔性铰链的最大应变为224.67μm.分析结果证明,所设计的直圆形双平行四连杆柔性铰链能够满足微进给机构的往复进给行程要求.
A micro feed mechanism was designed, which was driven by voice coil motor, supported by flexible hinge, and had a disk-spring installed behind the voice coil motor to improve its damping property. The flexure hinge was designed as a double parallel four-bar mechanism, and its maximum displacement and stress under peak motor thrust calculated. The results verify that the maximum strain of flexible hinge is 224. 67 μm under the maximum motor thrust of 800 N, and the double parallel four-bar flexible hinge can meet the requirements of reciprocating feed strokes of the micro feed mechanism.
出处
《厦门理工学院学报》
2014年第5期12-15,共4页
Journal of Xiamen University of Technology
基金
国家自然科学基金面上项目(51375411)
福建省教育厅科技项目(JA13232)
厦门理工学院高层次人才引进项目(YKJ12013R)
关键词
微进给机构
柔性铰链
有限元分析
平行四连杆机构
静力学分析
micro feed mechanism
flexible hinge
finite element analysis
parallel four-bar mechanism
static analysis
