期刊文献+

热压条件下Cu/Al复合带界面扩散反应研究 被引量:5

Interfacial diffusion reaction of Cu/Al laminates under hot pressing
原文传递
导出
摘要 研究了经冷轧复合的Cu/Al复合带在热压温度为500℃、实际压下率为0%~35%变形条件下的铜铝界面扩散反应。结果表明,在此界面扩散反应的过程中,存在晶界扩散机制。 Cu/Al复合界面扩散反应生成相次序受相变热力学和扩散动力学两方面因素共同控制,不但与各相生成吉布斯自由能有关,而且遵守通量-能量原则。虽然增加压下率对界面扩散层的生长起到一定的促进作用,但温度仍然是其主要影响因素。 The interfacial diffusion reaction of cold-rolled Cu/Al laminates was studied under the deformation condition that the temperature was 500 ℃and the reduction rate was 0%to 35%.The results show that there existed grain boundary diffusion mechanism in the process of interfacial diffusion and reaction .The formation sequence of intermediate phases on the Cu /Al interface depends on both the diffusion kinetic and thermodynamic phase transition .It was not only related to Gibbs free energy of forming each phase , but also followed the principle of flux-energy.Increasing the reduction rate played a role in promoting growth of Cu /Al interface diffusion zone , but temperature was still the most important factor which affects the Cu/Al interfacial diffusion zone growth .
出处 《金属热处理》 CAS CSCD 北大核心 2013年第10期42-45,共4页 Heat Treatment of Metals
基金 国家自然科学基金(50964006)
关键词 CU Al复合带 热压 界面扩散 热力学 动力学 copper/aluminum laminates hot press interface diffusion thermodynamics dynamics
  • 相关文献

参考文献16

二级参考文献55

共引文献194

同被引文献38

  • 1王斌,朱加祥,周翠,冯泉,陈礼波.5052与6061异种铝合金搅拌摩擦焊接头的组织和力学性能[J].金属热处理,2015,40(1):55-59. 被引量:15
  • 2张胜华,郭祖军.铜-铝复合材料的研究[J].中国有色金属学报,1995,5(4):128-132. 被引量:33
  • 3Li L, Nagai K, Yin F. Progress in cold roll bonding of metals [ J ]. Science and Technology of Advanced Materials, 2008, 9(2) : 1-11. 被引量:1
  • 4Kawase H, Makimoto M, Takagi K, et al. Development of aluminum clad steel by roll bonding [ J ]. Transactions of the Iron and Steel Institute of Japan, 1983, 23(7) : 628-632. 被引量:1
  • 5Danesh Manesb H, Karimi Taberi A. The effect of annealing treatment on mechanical properties of aluminum clad steel sheet [ J]. Materials and Design, 2003, 24: 617-622. 被引量:1
  • 6Springer H, Kostka A, Payton E J, et al. On the formation and growth of inter-metallic phases during inter-diffusion between low-carbon steel and aluminum alloys[ J]. Aeta Materialia, 2011, 59 (4) : 1586-1600. 被引量:1
  • 7Hodgson P D, Hiekson M R, Gibbs R K. Ultrafine ferrite in low carbon steel[ J ]. Seripta Materialia, 1999, 40 ( 10 ) : 1179-1184. 被引量:1
  • 8Laasraoui A, Jonas J J. Recrystallization of austenite after deformation at high temperatures and strain rates-analysis and modeling [ J ]. Metallurgical Transactions A, 1991, 22( 1 ) : 151-160. 被引量:1
  • 9Kobayashi S, Yakou T. Control of intermetallic compound layers at interface between steel and aluminum by diffusion-treatment [ J ]. Materials Science and Engineering : A, 2002, 338 ( 1 ) : 44-53. 被引量:1
  • 10Bay N. Mechanisms producing metallic bonds in cold welding [ J ]. Welding Research Supplement, 1983, 5 : 137-142. 被引量:1

引证文献5

二级引证文献32

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部