摘要
文章采用TRACEPRO软件建立了三种白光LED的光学模型:(1)芯片直接涂覆荧光粉;(2)芯片涂覆硅胶后涂覆荧光粉层;(3)芯片涂覆荧光粉后涂覆硅胶层。通过改变荧光粉的摩尔浓度或硅胶厚度来考察白光LED的光色指标,如光通量、色温及显色指数的变化。研究结果表明:第一种和第二种涂覆方式中,光色指标随着荧光粉摩尔浓度或硅胶厚度的改变呈规律性变化;第三种涂覆方式中,色温及显色指数的变化趋势不稳定,第三种方式光通量高于前两种,最大值可达到87.3 lm。三种方式的显色指数在70左右。研究结论为白光LED工艺设计提供参考和依据。
In this paper, the TRACEPRO software was used to establish three white LED optical models： （1） chip with directly coated phosphor, （2） chip with coated silica gel then with a phosphor layer, （3） chip with coated phosphor then with a silica gel layer. The influence of the phosphor concentration or silicone layer thickness on the white LED luminous flux, color temperature and color rendering index （CRI） was studied, respectively. The simulations show that for the first and second phosphor coating methods, luminous flux, color temperature and color rendering index change regularly with the phosphor concentration or silica gel thickness. For the third coating method, the color temperature and color rendering index have an unstable trend with thephosphor concentration or silica gel thickness. The luminous flux of the third phosphor coating LED is higher than that of the mentioned above two methods LED, which reaches 87.31m. The CRI of the three coating LED is about 70. The results provide the reference and basis for white LED process design.
出处
《现代显示》
2013年第1期43-48,共6页
Advanced Display
基金
广西制造系统与先进制造技术重点实验室项目(No.1103112001)
广西自然科学基金项目(No.2010GXNSFD013039
2012jjFAG0004)资助项目
关键词
LED
荧光粉
涂覆方式
光色指标
light emitting diode
phosphor
coating
performance
