期刊文献+

二维振动参数对半固态ZL104合金微观组织的影响 被引量:2

Effect of parameters of two dimensional vibration on microstructures of semi-solid ZL104 alloy
下载PDF
导出
摘要 利用自制的倾斜板内安置扰流柱,可实现三维振动的倾斜剪切流变装置,研究二维振动方向和振动频率对半固态ZL104合金组织的影响,分析振动方向XY、YZ、XZ对半固态ZL104合金组织的作用机理。结果表明:振动方向为XZ时,倾斜板上向下流动的合金液中,初生枝晶和液体之间产生的相对运动较大,初生晶粒之间发生碰撞和摩擦的几率多,晶粒细小,形状圆整;合金液在倾斜板上滞留的时间长,初生固相率高。随振动频率增大,晶粒尺寸减小,形状因子增大。当振动频率为50 Hz时,初生固相率为56.09%,晶粒尺寸为6.53μm,形状因子为0.57。 The influence of two dimensional vibration directions and frequency on the structures of ZL104 alloy was studied by the disturbing pillars installed in a self-designed sloping board, which is a rheological experimental facility with sloping, cooling and shearing function and three-dimensional vibration function. The action mechanism of vibration direction XY, YZ and XZ on the microstructure of the alloy was analyzed. The results show that on the vibration direction XZ, the relative motion given between primordial dendrite and molten ZL104 alloy is severe in molten ZL104 alloy down flow on the sloping board. Because the probability of collision and friction among the primordial grains is plentiful, the grains are refined, and their shapes are orbicular. The long the residence time of the molten ZL104 alloy on the sloping board, the plentiful the primordial solid phase. With the increase of vibration frequency, the shape factor increases and the grain size decreases. When the vibration frequency is 50 Hz, the proportion of primordial solid phase reaches 56.09%, the grain size is 6.53 μm and the shape factor is 0.57.
出处 《中国有色金属学报》 EI CAS CSCD 北大核心 2013年第3期673-678,共6页 The Chinese Journal of Nonferrous Metals
基金 河北省自然科学基金(E2010000880) 河北省专家出国培训项目资助(2010194)
关键词 二维振动 振动方向 振动频率 半固态 ZL104合金 two-dimension vibration vibration direction vibration frequency semi-solid ZL104 alloy
  • 相关文献

参考文献16

  • 1QIU P Q, NOMURA H Y, TAKITA M. Improvement of microstructure and tensile properties of cast iron by semi-solid casting[J]. Foundry Engineering, 1999, 71 (10): 685-690. 被引量:1
  • 2PIAO Long-yun, TETSUICHI M. Influence of BN film of inclined cooling plate on solid fraction in semi-solid slurry[J]. Journal of the Japan Institute of Metals, 2004, 68(4): 228-231. 被引量:1
  • 3FUMI T, TETSUICHI M. Grain refining of semi-solid Cu-Sn alloys castings using an inclined cooling plate[J]. Copper and Copper Alloy, 2004, 43(1): 177-182. 被引量:1
  • 4MOTEGI T. Continuous casting of semi-solid Mg-9%AI-l%Zn alloy[C]//Proceedings of the 7th International Conference on Semi-Solid Processing of Alloys and Composites. Tsukuba, Japan: National Institute of Advanced Industrial Science and Technology, 2002: 831-836. 被引量:1
  • 5管仁国,康立文,杜海军,温景林,崔建忠.倾斜式冷却剪切技术制备Al-3%Mg半固态合金坯料[J].中国有色金属学报,2006,16(5):811-816. 被引量:17
  • 6MUUMBO A, NOMURA H. Casting of semi-solid cast iron slurry using combination of cooling slope and pressurization[J]. International Journal Cast Metals Research, 2004(1): 39-46. 被引量:1
  • 7TOSHIO H. Semi-solid strip casting using a twin roll casting equipped with a cooling slope[J]. Journal of Materials Processing Technology, 2002, 130(11): 558-561. 被引量:1
  • 8TANABE F. Continuous casting of semi-solid AC4CH aluminum alloy produced using an inclined cooling plate[J]. Journal of the Japan Institute of Metals, 2003, 67(6): 291-294. 被引量:1
  • 9戴安国,邢书明,和优锋.倾斜冷却半固态连铸A356铝合金过程稳定性研究[J].铸造,2006,55(3):239-241. 被引量:7
  • 10谢丰广,管仁国,王付兴,刘相华.新型倾斜板技术制备A2017半固态合金[J].特种铸造及有色合金,2008,28(10):766-768. 被引量:14

二级参考文献101

共引文献69

同被引文献32

引证文献2

二级引证文献8

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部