摘要
以含钴介孔分子筛为催化剂、乙醇为碳源,采用CVD法制备碳纳米管(CNTs)。通过原位合成法制备一系列不同碳纳米管含量的碳纳米管/羟基磷灰石(CNTs/HA)复合材料。分别采用XRD、FTIR、TEM、N2吸附-脱附和Raman光谱等分析手段,对所合成CNTs/HA复合材料的晶相、结构、形貌和比表面积等进行了表征。同时研究了碳纳米管的添加量对所合成CNTs/HA复合材料形貌的影响。XRD与Raman结果表明,所得CNTs/HA复合粉体中仅有CNTs与HA两种物相,纯度较高,结晶度较好;TEM结果显示,CNTs/HA复合材料中CNTs表面均匀包裹着一层纳米级的针状HA晶粒,两者形成了较强的界面结合,且当CNTs与HA的质量比为3∶17时,CNTs与HA形成最佳结合状态;N2吸附-脱附表征结果表明,与HA的比表面积相比,CNTs/HA复合材料具有较高比表面积。
Carbon nanotuhes （CNTs） were prepared by chemical vapor deposition （CVD） method using Co- containing mesoporous molecular sieve as catalyst and ethanol as carbon source. A series of carbon nanotubes/ hydroxyapatite （CNTs/HA） composites with different amounts of CNTs were synthesized by using an in- situ method. The structure, morphology, crystal phase and the surface area of the as-synthesized CNTs/HA composites were characterized by XRD, FTIR, TEM, N2 physical adsorption - desorption and Raman spectroscopy. At the same time, the effect of CNTs on the morphology of the CNTs/HA composites was also investigated. XRD and Raman results show that CNTs/HA composites exhibit two kinds of crystal phases including CNTs and HA with good quality and crystallinity. TEM results reveal that the surface of CNTs was uniformly wrapped by nano-sized and needle-liked HA particles, and the good interfacial bonding exists between CNTs and HA. The optimal combination can be achieved between HA and CNTs when the mass ratio of CNTs to HA is 3 ：17. N2 adsorption- desorption results indicate that CNTs/HA composites have high specific surface area as compared with HA.
出处
《复合材料学报》
EI
CAS
CSCD
北大核心
2012年第3期85-89,共5页
Acta Materiae Compositae Sinica
基金
江苏省高校自然科学基金(09KJD150002)
江苏大学高校级人才基金(10JDG114)
关键词
碳纳米管
羟基磷灰石
原位合成
复合材料
表征
carbon nanotubes
hydroxyapatite（HA）
in situ synthesis~ composites
characterization
