摘要
为分析单狭缝、双狭缝和四狭缝射流冲击柱状凸形表面的流动换热特性,应用Realizable k-模型对其展开数值研究。通过与实验数据对比验证了数学模型的适用性,比较探讨了单、多狭缝冲击射流的流场分布、边界层分离现象和冲击换热特点。结果表明:单、多狭缝射流冲击柱状凸形表面,气体分别在流动阻力和相邻狭缝射流逆向相遇阻力形成的逆压梯度作用下,发生边界层分离;随流动发展,多狭缝射流在相邻射流逆向相遇作用下,Nu迅速下降至最低值,随后在逆流作用下有所回升;每狭缝具有相同雷诺数Re条件下,当狭缝数目增加时,Re的增加对提高平均努塞尔数Num的效果相对较小,当无量纲曲率半径(D/B)增大时,Num对Re的变化更加敏感,增大Re将有效地增加表面Num;狭缝射流总流量一定时,狭缝数目越多,Num越小,局部努塞尔数Nu分布越均匀。
Flow and heat transfer of single-slot jet, double-slot jets and quadric-slot jets impingement to a cylindrical convex surface were numerically investigated by realizable k-ε model. The numerical model was validated through comparison with the experimental data. Flow distribution, boundary layer separation and impingement heat transfer were discussed and compared. The results show that： Boundary layer separation occurs in both of single and multiple-slot jets impingement due to adverse pressure gradient caused by the resistance of flow and reverse encountering of the adjacent slot jets, respectively. With flow development, Nu drops rapidly to the minimum due to the reverse encountering flow in multiple-slot jets and then has a small increase due to the adverse flow. Under the same Re of each slot, the effect of increasing Re is relative small on raising Num when slots number increases. While the effect of Re on Nu,, becomes more sensitive with increasing dimensionless curvature radius（D/B）. Nu,, could be effectively increased by increasing Re under big D/B. Under a constant total flow rate, Num decreases but uniformity of local Nu increases with increasing slots number.
出处
《中国电机工程学报》
EI
CSCD
北大核心
2012年第2期93-98,共6页
Proceedings of the CSEE
关键词
狭缝射流
凸形表面
边界层分离
流动换热
slot jets impingement
convex surface
boundary layer separation
flow and heat transfer
