期刊文献+

Al-Cu-Mg-Ag耐热铝合金的热稳定性 被引量:9

Thermal stability of Al-Cu-Mg-Ag heat-resistant alloy
下载PDF
导出
摘要 采用力学拉伸性能测试和透射电镜微观组织观察,分析欠时效态和峰时效态Al-Cu-Mg-Ag合金的热稳定性,并研究热暴露温度和时间对合金组织与力学性能的影响。结果表明:在150℃下,欠时效态合金的稳定性能明显优于峰时效态合金的;峰时效态合金的抗拉强度随着热暴露时间的延长逐渐减小,合金中的强化相-相和少量的θ′相逐渐发生粗化;欠时效态合金的抗拉强度随热暴露时间的延长先增大后减小,合金组织中的析出相数量先增多后减少,并发生粗化;热暴露20 h后,欠时效态合金的抗拉强度达到峰值524 MPa,比峰时效态合金的强度高19 MPa;此时,合金组织中的-相呈弥散分布,并且出现大量细小的θ′相;欠时效态合金在150℃下热暴露1 000 h后,其抗拉强度减小为434 MPa,仍能达到峰时效态合金的86%;当热暴露温度升高至200℃时,随热暴露时间的延长,欠时效态合金的抗拉强度减小,伸长率增大;热暴露1 000 h后,其抗拉强度降低到307 MPa;在250和300℃下热暴露时,欠时效态合金的抗拉强度随时间的延长急剧减小,组织中的强化相数量明显减少,并逐步演变成粗大的平衡相θ相。 The thermal stability of Al-Cu-Mg-Ag alloys under-aged and peak-aged was analyzed by tensile test and transmission electron microscopy(TEM).And the effects of thermal exposure temperature and holding time on the microstructure and mechanical properties of Al-Cu-Mg-Ag alloy were also studied.The results show that the thermal stability of the under-aged Al-Cu-Mg-Ag alloy is superior to that of the peak-aged alloy when exposed at 150 ℃.The tensile strength of the peak-aged alloy decreases with prolonging the holding time.And the strengthening phases Ω and little θ′ are coarsened gradually.The tensile strength of the under-aged alloy increases and then decreases with prolonging the time.And the number of the precipitations increases and then decreases with the slowly coarsening of the precipitations.The tensile strength of Al-Cu-Mg-Ag alloy reaches the peak value of 524 MPa after exposed for 20 h,which is 19 MPa larger than that of the peak-aged alloy.Meanwhile the precipitations Ω distribute dispersively and a large amount of fine θ′ phase is observed.The tensile strength of the under-aged alloy is 434 MPa after exposed at 150 ℃ for 1 000 h,which is 86% of that of the peak-aged alloy.When exposed at 200 ℃,the tensile strength decreases and the prolongation increases with prolonging the exposure time.The tensile strength decreases to 307 MPa after exposed for 1 000 h.The tensile strength decreases dramatically with prolonging the holding time.And the number of the strengthening phases decreases obviously and grows to equilibrium phase θ.
出处 《中国有色金属学报》 EI CAS CSCD 北大核心 2011年第6期1244-1251,共8页 The Chinese Journal of Nonferrous Metals
基金 国防科工委军品配套研制项目(JPPT-115-2-948) 中南大学优秀博士学位论文扶植基金资助项目(2008yb012)
关键词 AL-CU-MG-AG合金 热暴露 欠时效 力学性能 显微组织 Al-Cu-Mg-Ag alloy exposure under-aging mechanical properties microstructure
  • 相关文献

参考文献16

  • 1CHANG C H, LEE S L, LIN J C, YEH M S, JENG R R. Effect of Ag content and heat treatment on the stress corrosion cracking of AI-4.6Cu-0.3Mg alloy[J]. Materials Chemistry and Physics, 2005, 91(2/3): 454-462. 被引量:1
  • 2XIAO D H, WANG J N, DING D Y, CHEN S P. Effect of Cu content on the mechanical properties of an AI-Cu-Mg-Ag alloy[J]. Journal of Alloys and Compounds, 2002, 343(1/2): 77-81. 被引量:1
  • 3刘延斌,刘志义,李云涛,邓才智.时效对2524铝合金热稳定性的影响[J].材料研究学报,2007,21(6):585-588. 被引量:10
  • 4KERMANIDIS A T, ZERVAKI A D, HAIDEMENOPOULOS G N, PANTELAKIS SP G. Effects of temper condition and corrosion on the fatigue performance of a laser-welded A1-Cu-Mg-Ag (2139) alloy[J]. Materials & Design, 2010, 31(1): 42-49. 被引量:1
  • 5LUMLEY R N, MORTON A J, POLMEAR 1 J. Enhanced creep performance in an AI-Cu-Mg-Ag alloy through underageing[J]. Acta Materialia, 2002, 50(14): 3597-3608. 被引量:1
  • 6LUMLEY R N, POLMEAR I J. The effect of long term creep exposure on the microstructure and properties of an underaged AI-Cu-Mg-Ag alloy[J]. Scripta Materialia, 2004, 50(9): 1227-1231. 被引量:1
  • 7魏修宇,郑子樵,陈小珍,李世晨.ML377铝锂合金热稳定性研究[J].材料热处理学报,2008,29(1):71-74. 被引量:2
  • 8LUMLEY R N, POLMEAR I J, MORTON A J. Heat treatment of age-hardenable aluminum alloys: US7025839B2[P]. 2006. 被引量:1
  • 9VIETZ J T, POLMEAR 1 J. The influence of small additions of silver on the ageing of aluminium alloys observations AI-Cu-Mg alloys[J]. Journal of the Institute of Metals, 1966, 94(12): 410-419. 被引量:1
  • 10肖代红..微合金化对AL-CU-MG基耐热铝合金的显微组织和力学性能的影响[D].上海交通大学,2004:

二级参考文献47

  • 1陈志国,郑子樵,王芝秀,李世晨.锂对低Cu/Mg比Al-Cu-Mg-Ag合金时效特性的影响[J].材料研究学报,2004,18(5):517-523. 被引量:2
  • 2陆政,强俊,吴一雷,李永伟,刘伯操.热暴露对铝锂8090合金挤压型材性能的影响[J].兵器材料科学与工程,1996,19(4):25-29. 被引量:4
  • 3李云涛,刘志义,夏卿坤,余日成,刘延斌.稀土铒对Al-Cu-Mg-Ag-Zr合金微观组织与时效行为的影响[J].材料热处理学报,2007,28(2):49-53. 被引量:19
  • 4K.M.Starin, N.Gao, N.Kamp, et al., Relations between microstructure, precipitation, age-formability and damage tolerance of Al-Cu-Mg-Li(Mn, Zr, Sc) alloys for age forming, Materials Science and Engineering A, 418(1), 241(2006). 被引量:1
  • 5S.P.Ringer, T.Sakurai, I.J.Polmear, Origins of hardening in aged Al-Cu-Mg-(Ag) alloys, Acta Materialia, 45(9), 3731(1997). 被引量:1
  • 6S.P.Ringer, K.Hono, T.Sakurai, Polmear, Ian J., Cluster hardening in an aged Al-Cu-Mg alloy, Scripta Materialia, 36(5), 517(1997). 被引量:1
  • 7S.P.Ringer, K.Hono, I.J.Polmear, T.Sakurai, Precipitation processes during the early stages of ageing in Al-Cu-Mg alloys, Applied Surface Science, 94-95,253(1996). 被引量:1
  • 8T.S.Srivatsan, D.Kolar, P.Magnusen, Influence of temperature on cyclic stress response, strain resistance, and fracture behavior of aluminum alloy 2524, Materials Science and Engineering A, 314(1-2), 118(2001). 被引量:1
  • 9T.S.Srivatsan, D.Kolar, P.Magnusen, The cyclic fatigue and final fracture behavior of aluminum alloy 2524, Materials and Design, 23(2), 129(2002). 被引量:1
  • 10G.H.Bray, M.Glazov, R.J.Rioja, Effect of artificial aging on the fatigue crack propagation resistance of 2000 series aluminum alloys, International Journal of Fatigue, 23, n(1),265(2001). 被引量:1

共引文献12

同被引文献76

引证文献9

二级引证文献25

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部