摘要
在430℃对AISI304奥氏体不锈钢分别进行离子渗氮(PN)、离子氮碳共渗(PNC)和离子氮碳共渗加离子渗氮(PNC+PN)处理。利用金相显微镜、辉光放电光谱仪、X射线衍射仪和显微硬度计测试了试样渗层的横断面形貌、渗层成分、相组成和力学性能。结果表明,AISI304奥氏体不锈钢在430℃进行硬化处理时,相对于PN处理,经PNC和PNC+PN处理可以获得更高硬度、更厚渗层,但表面耐腐蚀性下降,3种处理得到的渗层中C和N的最大含量分别出现在不同深度。
Plasma nitriding（PN）,plasma nitrocarburising（PNC） and their combination processes at 430 ℃ of AISI304 austenitic stainless steel were conducted.Cross-section morphology,chemical composition,phase composition and mechanical properties of the modified layer were tested by metalloscope,glow discharge spectrometry（GDS）,X-ray diffraction（XRD） and microhardness tester.The results show that the samples of AISI304 steel treated by PNC and PNC＋PN processes have higher hardness,thicker layer than the sample treated by PN process,and the corrosion resistance of the samples is lower,the maximum N and C content in the layer are in different depths.
出处
《金属热处理》
CAS
CSCD
北大核心
2011年第4期31-34,共4页
Heat Treatment of Metals
基金
国家自然科学基金(50901058)
深圳市基础研究计划(2009-K1-54)
