期刊文献+

油田压裂废水的絮凝-Fenton氧化-SBR联合处理实验研究 被引量:6

Application of Flocculation-Fenton Oxidation-SBR Process on Treating Oil Field Fracturing Wastewater
下载PDF
导出
摘要 针对中原油田压裂作业废水矿化度高、悬浮性固体(SS)含量高和有机物含量高且性质稳定的特点,采用絮凝-Fenton氧化-SBR联合处理方法对压裂废水进行了处理条件研究。结果表明:压裂废水COD值为2000 mg/L~3000 mg/L时,聚合硫酸铁(PFS)加量为50 mg/L、聚丙烯酰胺(PAM)加量为4 mg/L、搅拌速度100 r/min下进行絮凝沉降30 min,再于H2O2投加量为1000 mg/L、FeSO4投加量为150 mg/L、反应温度为40℃条件下氧化处理45 min后,进入SBR反应器曝气8 h和沉降1 h后,处理后压裂废水的COD去除率可达95.43%,出水COD值降至125.84 mg/L,达到国家二级排放标准(GB8978-1996)。 According to the characteristics of fracturing wastewater from Zhongyuan oilfield,which has high salinity,suspended solids and organism concentration,the process of flocculation-Fenton oxidation-SBR was applied. The results showed that the fracturing wastewater diluting 3 times has better flocculated effect when the dosage of poly ferric sulfate (PFS) and polyacrylamide(PAM) were50 mg/L and 4mg/L respectively,and the stirring rate was100r/mmin. Then the flocculated fracturing wastewater was oxidized for 45min under the condition of 1000mg/L H2 O2,150mg/L Fe2SO4 respectively and under the temperature of 40℃. The COD concentration of the fracturing wastewater was dropped from 2753. 3mg/L to 125. 84mmg/L,and theCOD removing rate was 95.43%,after the flocculation-fenton oxidized wastewater was treated in the sequence batch reactor treatment (SBR)with 8 hours aerating time and 1 hour settling time.
出处 《石油与天然气化工》 CAS CSCD 2011年第1期95-99,12,共5页 Chemical engineering of oil & gas
基金 陕西省"13115"科技创新工程重大科技专项项目(2009ZDKG-61) 西安石油大学科技创新基金项目(2005-36)
关键词 压裂废水 絮凝 Fenton氧化SBR COD值 fracturing wastewater flocculation Fen-ton oxidation SBR COD
  • 相关文献

参考文献16

二级参考文献51

共引文献855

同被引文献44

引证文献6

二级引证文献22

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部