A common current source, generally used to bias cross-coupled differential amplifiers in a transconductor, controls third harmonic distortion (HD3) poorly. Separate current sources are shown to provide better control ...A common current source, generally used to bias cross-coupled differential amplifiers in a transconductor, controls third harmonic distortion (HD3) poorly. Separate current sources are shown to provide better control on HD3) . In this paper, a detailed design and analysis is presented for a transconductor made using this biasing technique. The transconductor, in addition, is made to offer high Gm, low power dissipation and is designed for linearly tunable Gm with current mode load as one of the applications. The circuit exhibits HD3) of less than –43.7 dB, high current efficiency of 1.18 V-1 and Gm of 390 μS at 1 VGp-p @ 50 MHz. UMC 0.18 μm CMOS process technology is used for simulation at supply voltage of 1.8 V.展开更多
This paper presents a new first order all pass filter configurations. The proposed all pass filter configuration employs two configurations namely VDVTA and OTAs based first order all pass filter configuration. The fi...This paper presents a new first order all pass filter configurations. The proposed all pass filter configuration employs two configurations namely VDVTA and OTAs based first order all pass filter configuration. The first proposed configuration employs a single VDVTA and one grounded capacitor whereas the second proposed configuration employs two OTAs and one grounded capacitor. Both types of proposed configurations are fully electronically tunable and their quality factors do not depend on tunable pole frequency range. The reported configurations yield low active and passive sensitivities and also have low power consumption with very low supply voltage ± 0.85 V with Bias Voltage ± 0.50 V. The PSPICE simulation of the proposed VDVTA and two OTAs based first order all pass filter configurations are verified using 0.18 μm CMOS Technology Process Parameters.展开更多
采用电压控制的伪电阻结构,设计了一款具有超低频下截止频率调节功能的带通可变增益放大器(VGA),由于该结构具有可调节超大的等效电阻和反馈电容使VGA的下截止频率可以调节。提出了一种改进的甲乙类运算跨导放大器(OTA)结构,采用新颖的...采用电压控制的伪电阻结构,设计了一款具有超低频下截止频率调节功能的带通可变增益放大器(VGA),由于该结构具有可调节超大的等效电阻和反馈电容使VGA的下截止频率可以调节。提出了一种改进的甲乙类运算跨导放大器(OTA)结构,采用新颖的浮动偏置设计,在满足高压摆率的条件下,有效提高共源共栅结构的电压输出范围。将伪电阻用于OTA的共模反馈,克服了阻性共模检测结构负载效应的问题。该VGA电路采用TSMC 0.18μm标准工艺设计和流片,测试结果表明,1.2 V电源电压下,其下截止频率调节范围为1.3~244 Hz,增益为49.2,44.2,39.2 d B,带宽为3.4,3.9,4.4 k Hz,消耗电流为3.9μA,共模抑制比达75.2 d B。展开更多
This paper presents the design of a two-stage bulk-input pseudo-differential operational transconductance amplifier (OTA) and its application in active-RC filters. The OTA was designed in 90 nm CMOS process and operat...This paper presents the design of a two-stage bulk-input pseudo-differential operational transconductance amplifier (OTA) and its application in active-RC filters. The OTA was designed in 90 nm CMOS process and operates at a single supply voltage of 0.5 V. Using a two-path bulk-driven OTA by the combination of two different amplifiers the DC gain and speed of the OTA is increased. Rail-to-rail input is made possible using the transistor’s bulk terminal as in input. Also a Miller-Feed-forward (MFF) compensation is utilized which is improved the gain bandwidth (GBW) and phase margin of the OTA. In addition, a new merged cross-coupled self-cascode pair is used that can provide higher gain. Also, a novel cost-effective bulk-input common-mode feedback (CMFB) circuit has been designed. Simplicity and ability of using this new merged CMFB circuit is superior compared with state-of-the-art CMFBs. The OTA has a 70.2 dB DC gain, a 2.5 MHz GBW and a 70.8o phase margin for a 20 PF capacitive load whereas consumes only 25 μw. Finally, an 8th order Butterworth active Biquadrate RC filter has been designed and this OTA was checked by a typical switched-capacitor (SC) integrator with a 1 MHz clock-frequency.展开更多
文摘A common current source, generally used to bias cross-coupled differential amplifiers in a transconductor, controls third harmonic distortion (HD3) poorly. Separate current sources are shown to provide better control on HD3) . In this paper, a detailed design and analysis is presented for a transconductor made using this biasing technique. The transconductor, in addition, is made to offer high Gm, low power dissipation and is designed for linearly tunable Gm with current mode load as one of the applications. The circuit exhibits HD3) of less than –43.7 dB, high current efficiency of 1.18 V-1 and Gm of 390 μS at 1 VGp-p @ 50 MHz. UMC 0.18 μm CMOS process technology is used for simulation at supply voltage of 1.8 V.
文摘This paper presents a new first order all pass filter configurations. The proposed all pass filter configuration employs two configurations namely VDVTA and OTAs based first order all pass filter configuration. The first proposed configuration employs a single VDVTA and one grounded capacitor whereas the second proposed configuration employs two OTAs and one grounded capacitor. Both types of proposed configurations are fully electronically tunable and their quality factors do not depend on tunable pole frequency range. The reported configurations yield low active and passive sensitivities and also have low power consumption with very low supply voltage ± 0.85 V with Bias Voltage ± 0.50 V. The PSPICE simulation of the proposed VDVTA and two OTAs based first order all pass filter configurations are verified using 0.18 μm CMOS Technology Process Parameters.
文摘采用电压控制的伪电阻结构,设计了一款具有超低频下截止频率调节功能的带通可变增益放大器(VGA),由于该结构具有可调节超大的等效电阻和反馈电容使VGA的下截止频率可以调节。提出了一种改进的甲乙类运算跨导放大器(OTA)结构,采用新颖的浮动偏置设计,在满足高压摆率的条件下,有效提高共源共栅结构的电压输出范围。将伪电阻用于OTA的共模反馈,克服了阻性共模检测结构负载效应的问题。该VGA电路采用TSMC 0.18μm标准工艺设计和流片,测试结果表明,1.2 V电源电压下,其下截止频率调节范围为1.3~244 Hz,增益为49.2,44.2,39.2 d B,带宽为3.4,3.9,4.4 k Hz,消耗电流为3.9μA,共模抑制比达75.2 d B。
文摘This paper presents the design of a two-stage bulk-input pseudo-differential operational transconductance amplifier (OTA) and its application in active-RC filters. The OTA was designed in 90 nm CMOS process and operates at a single supply voltage of 0.5 V. Using a two-path bulk-driven OTA by the combination of two different amplifiers the DC gain and speed of the OTA is increased. Rail-to-rail input is made possible using the transistor’s bulk terminal as in input. Also a Miller-Feed-forward (MFF) compensation is utilized which is improved the gain bandwidth (GBW) and phase margin of the OTA. In addition, a new merged cross-coupled self-cascode pair is used that can provide higher gain. Also, a novel cost-effective bulk-input common-mode feedback (CMFB) circuit has been designed. Simplicity and ability of using this new merged CMFB circuit is superior compared with state-of-the-art CMFBs. The OTA has a 70.2 dB DC gain, a 2.5 MHz GBW and a 70.8o phase margin for a 20 PF capacitive load whereas consumes only 25 μw. Finally, an 8th order Butterworth active Biquadrate RC filter has been designed and this OTA was checked by a typical switched-capacitor (SC) integrator with a 1 MHz clock-frequency.
