对云南某铅锌矿石测定原矿力学性质、粒度组成并通过磨矿介质的对比实验来解决其一段球磨机处理量偏低、细度不达标、产品粒度组成不合理等问题。实验结果表明,该矿石属于中硬偏软矿石,软硬分布不均匀,容重和韧性都偏高;控制工艺参数与...对云南某铅锌矿石测定原矿力学性质、粒度组成并通过磨矿介质的对比实验来解决其一段球磨机处理量偏低、细度不达标、产品粒度组成不合理等问题。实验结果表明,该矿石属于中硬偏软矿石,软硬分布不均匀,容重和韧性都偏高;控制工艺参数与现场接近,磨矿细度为-0.074 mm 65%时效果较佳;采用Φ80mm:Φ60mm:Φ40mm:Φ30mm=20:25:25:30钢球方案能提高磨矿效率和磨矿细度,同时降低过磨粒级含量。展开更多
The surface coating of grinding balls was investigated experimentally. The results show that a coating may form on the surface of grinding balls when Cr or Al powders are subjected to ball grinding. The plastic deform...The surface coating of grinding balls was investigated experimentally. The results show that a coating may form on the surface of grinding balls when Cr or Al powders are subjected to ball grinding. The plastic deformation of the ball surface plays an important role during the coating formation, and the strong binding force between the powders and the balls is a necessary pre-condition. The thickness of coating increases with the plasticity of the powders and the balls. Annealing the balls with coating will result in an obvious diffusion of the elements in the bonding zone of interface.展开更多
文摘对云南某铅锌矿石测定原矿力学性质、粒度组成并通过磨矿介质的对比实验来解决其一段球磨机处理量偏低、细度不达标、产品粒度组成不合理等问题。实验结果表明,该矿石属于中硬偏软矿石,软硬分布不均匀,容重和韧性都偏高;控制工艺参数与现场接近,磨矿细度为-0.074 mm 65%时效果较佳;采用Φ80mm:Φ60mm:Φ40mm:Φ30mm=20:25:25:30钢球方案能提高磨矿效率和磨矿细度,同时降低过磨粒级含量。
文摘The surface coating of grinding balls was investigated experimentally. The results show that a coating may form on the surface of grinding balls when Cr or Al powders are subjected to ball grinding. The plastic deformation of the ball surface plays an important role during the coating formation, and the strong binding force between the powders and the balls is a necessary pre-condition. The thickness of coating increases with the plasticity of the powders and the balls. Annealing the balls with coating will result in an obvious diffusion of the elements in the bonding zone of interface.
