A series of single bcc,bcc plus fcc duplex and single fcc microcrystalline coatings of 1Cr18Ni9Ti stainless steel were prepared by using sputtering technique.The resistance against pitting corrosion was studied by mea...A series of single bcc,bcc plus fcc duplex and single fcc microcrystalline coatings of 1Cr18Ni9Ti stainless steel were prepared by using sputtering technique.The resistance against pitting corrosion was studied by measurements of pitting corrosion potentials and electrochemical noise during initiation of corrosion pits.The results show that the sputtered coatings with single bcc phase or single fcc structure are more resistant to pitting corrosion than those with bcc plus fcc duplex phase structure.展开更多
The radiation damage of 1Cr18Ni9Ti stainless steel and the Zr-Ti-Al alloy by 200 keV Xe＋ ions bombardment at the fluence ranging from 1×1014 to 8×1015 ions/cm2 has been investigated by conventional transmis...The radiation damage of 1Cr18Ni9Ti stainless steel and the Zr-Ti-Al alloy by 200 keV Xe＋ ions bombardment at the fluence ranging from 1×1014 to 8×1015 ions/cm2 has been investigated by conventional transmission electron microscope, X-ray diffraction line profile analysis （XRDLPA） and nanoindentation. XRDLPA shows that the order of magnitude of dislocation density in both materials remains almost unchanged up to the highest irradiation dose. Selected-area electron diffraction combined with bright and dark field image indicates that 1Cr18Ni9Ti is more easily damaged than the Zr-Ti-Al alloy. With increasing the ions fluence, the radiation damage became more severe in 1Cr18Ni9Ti, accompanied with phase transition and partial amorphization. The nano-hardness was found to increase rapidly with increasing ion fluence till the dose of 1×1015 ions/cm2, and then gradually saturate with dose. The enhancement of hardness in irradiated materials is due to irradiation-induced defects acting as barriers to dislocation motion.展开更多
The tribological properties of ZrO2 ceramic and 1Cr18Ni9Ti stainless steel rubbing pairs were investigated using a special tribo-tester under different concentrations of hydrogen peroxide (H2O2) solution.The compariso...The tribological properties of ZrO2 ceramic and 1Cr18Ni9Ti stainless steel rubbing pairs were investigated using a special tribo-tester under different concentrations of hydrogen peroxide (H2O2) solution.The comparison analyses of the friction coefficients,worn volume rates,worn particles and surface roughness were conducted under the tested conditions.There were significant differences of the tribological properties of the rubbing pairs in the different concentrations H2O2 solution because of oxidation and corrosion.This research has revealed that the main wear mechanisms between the rubbing pairs are severe adhesive wear,abrasive wear and corrosive wear in the H2O2 solution with different concentrations.A model has been established to assess the most suitable concentration of the H2O2 solution for the tribological properties of the rubbing pairs.The result shows that 50% concentration of the H2O2 solution is the most suitable.The assessment result is consistent with the experimental result.It is believed that the knowledge gained in this study is useful for the optimization of the friction pairs in the extreme condition.展开更多
文摘A series of single bcc,bcc plus fcc duplex and single fcc microcrystalline coatings of 1Cr18Ni9Ti stainless steel were prepared by using sputtering technique.The resistance against pitting corrosion was studied by measurements of pitting corrosion potentials and electrochemical noise during initiation of corrosion pits.The results show that the sputtered coatings with single bcc phase or single fcc structure are more resistant to pitting corrosion than those with bcc plus fcc duplex phase structure.
基金supported by the National Natural Science Foundation of China(Grant No. 50871057)National Basic Research Program of China (Grant No. 2010CB731601)
文摘The radiation damage of 1Cr18Ni9Ti stainless steel and the Zr-Ti-Al alloy by 200 keV Xe＋ ions bombardment at the fluence ranging from 1×1014 to 8×1015 ions/cm2 has been investigated by conventional transmission electron microscope, X-ray diffraction line profile analysis （XRDLPA） and nanoindentation. XRDLPA shows that the order of magnitude of dislocation density in both materials remains almost unchanged up to the highest irradiation dose. Selected-area electron diffraction combined with bright and dark field image indicates that 1Cr18Ni9Ti is more easily damaged than the Zr-Ti-Al alloy. With increasing the ions fluence, the radiation damage became more severe in 1Cr18Ni9Ti, accompanied with phase transition and partial amorphization. The nano-hardness was found to increase rapidly with increasing ion fluence till the dose of 1×1015 ions/cm2, and then gradually saturate with dose. The enhancement of hardness in irradiated materials is due to irradiation-induced defects acting as barriers to dislocation motion.
基金supported by the Key Basic Research Program of China(Grant No.2007CB607603)the Program for New Century Excellent Talents in University(Grant No.NCET-12-0910)
文摘The tribological properties of ZrO2 ceramic and 1Cr18Ni9Ti stainless steel rubbing pairs were investigated using a special tribo-tester under different concentrations of hydrogen peroxide (H2O2) solution.The comparison analyses of the friction coefficients,worn volume rates,worn particles and surface roughness were conducted under the tested conditions.There were significant differences of the tribological properties of the rubbing pairs in the different concentrations H2O2 solution because of oxidation and corrosion.This research has revealed that the main wear mechanisms between the rubbing pairs are severe adhesive wear,abrasive wear and corrosive wear in the H2O2 solution with different concentrations.A model has been established to assess the most suitable concentration of the H2O2 solution for the tribological properties of the rubbing pairs.The result shows that 50% concentration of the H2O2 solution is the most suitable.The assessment result is consistent with the experimental result.It is believed that the knowledge gained in this study is useful for the optimization of the friction pairs in the extreme condition.
