摘要
This paper deals with the removal of noise and base wander in the transfer of ECG data from the patients to the doctor. The process of the project is receiving ECG signals from the patient and reading the data in PC using an Arduino (an open-source electronics prototyping platform based on flexible, easy-to-use hardware and software) board, and then the signal is subjected to the removal of noise and base wander by amplification circuits in LabView (a system design software) software. Thus obtained ECG signal is sent to the doctors using an Ethernet cable or LAN connection. This enables the doctors to monitor any number of patients more accurately by sitting in a single room.
This paper deals with the removal of noise and base wander in the transfer of ECG data from the patients to the doctor. The process of the project is receiving ECG signals from the patient and reading the data in PC using an Arduino (an open-source electronics prototyping platform based on flexible, easy-to-use hardware and software) board, and then the signal is subjected to the removal of noise and base wander by amplification circuits in LabView (a system design software) software. Thus obtained ECG signal is sent to the doctors using an Ethernet cable or LAN connection. This enables the doctors to monitor any number of patients more accurately by sitting in a single room.
作者
Dr. V. Nandagopal
Dr. V. Maheswari
C. Kannan
Dr. V. Nandagopal;Dr. V. Maheswari;C. Kannan(Department of Electrical and Electronics Engineering, Sreenivasa Institute of Technology and Management Studies, Murukambattu Chittoor, India;Department of Electrical and Electronics Engineering, Arunai Engineering College, Tiruvannamalai, India)
