期刊文献+

全配方发动机油SJ/5W-30中二烷基二硫代甲酸钼的磨擦学特性研究(Ⅰ)——二烷基二硫代甲酸钼(MoDTC)的减摩抗磨特性 被引量:7

Study of Tribological Behavior of Molybdenum Dithiocarbamate (MoDTC) Blended into A Fully Formulated Petroleum Based Engine Oil (SJ/5W-30) ( Ⅰ)——Friction-reduction and Anti-wear Performance of Molybdenum Dithiocarbamate (MoDTC)
下载PDF
导出
摘要 以渗氮层/灰铸铁摩擦副为对象,采用全配方矿物基发动机油SJ/5W-30作为基础润滑油,研究了油溶性有机钼添加剂二烷基二硫代甲酸钼(MoDTC)在125℃、250℃和320℃三种不同温度下的摩擦学特性。结果表明:MoDTC添加至全配方发动机油SJ/5W-30中能有效降低摩擦系数以及渗氮层/灰铸铁摩擦副的磨损程度。而且,温度越高,MoDTC的减摩抗磨作用越显著。磨损表面的SEM观察表明:温度升高,渗氮层与灰铸铁的磨损程度均增大。添加剂MoDTC的存在能显著减缓温度对磨损程度的影响。 Tribological behavior of molybdenum dithiocarbamate (MoDTC) blended into a fully formulated petroleum based engine oil (SJ/5W-30) in the case of the nitrided coating vs. cast iron at three temperatures was investigated. Results have shown that, for the designated tribosystem, MoDTC can both decrease friction and reduce wear, and, furthermore, the higher the temperature, the better the friction-reduction and anti-wear performance for MoDTC. In addition, SEM observations of worn surfaces indicated that the wear for the nitrided coating and cast iron would become more severe with the increase of the temperature. However, MoDTC can greatly decrease the change in wear severity caused by the temperature.
出处 《润滑与密封》 CAS CSCD 北大核心 2003年第3期33-35,共3页 Lubrication Engineering
关键词 油溶性有机钼添加剂 二烷基二硫代甲酸钼 发动机油 MODTC 渗氮层 灰铸铁 MoDTC Nitrided Coating Cast Iron Temperature Friction and Wear
  • 相关文献

参考文献8

  • 1王建昕等编著..汽车排气污染治理及催化转化器[M].北京:化学工业出版社,2000:317.
  • 2Korcek S, Sorab J, Johnson M D and Jensen R K. Automotive lubricants for the next millennium. Industrial Lubrication and Tribology, 2000, 52 (5): 209-220. 被引量:1
  • 3Johnson M D, Riley M. Low phosphorous engine oils. SAE paper No. 975286, 1997, 785-791. 被引量:1
  • 4Hong H- S. Lubrication of nonmetallic materials. Tribology Transactions, 1998, 41 (2) : 296 - 300. 被引量:1
  • 5Brown A J, Bell I A W, McConnachie J M and Stiefel E I.Molybdenum dithiocarbamates for enhanced friction control and fuel economy. Preprints, Division of Petroleum Chemistry, American Chemical Society, 1999, 44 (3) : 326-331. 被引量:1
  • 6Korcek S, Jensen R K and Johnson M D. Interactions leading to formation of low fricton films in systems containing molybdenum dithiocarbamate and zinc dialkyldithiophosphate additives. In:Dowson D ed. Proceedings of the 26^th Leeds- Lyon Symposium on Tribology. 被引量:1
  • 7Jensen R K, Korcek S. Effects of oxidation on the frictional behavior of molybdenum dithiocarbamate. Preprints, Division of Petroleum Chemistry. American Chemical Society, 1999, 44(3) : 322 -325. 被引量:1
  • 8Hyun S H. Effect of molybdenum dithiocarbamate and zinc dithiophosphate on the tribological behavior of Si3N4 and Ai2O3.Lubrication Engineering, 1994, 50 (8): 616-622. 被引量:1

同被引文献56

引证文献7

二级引证文献24

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部