摘要
激光干涉仪中光学元件表面划痕和灰尘等会在干涉图中形成衍射环状相干噪声,极大影响测量精度。为了消除此类相干噪声,提出了一种基于多模光纤耦合角度变化的扩展光源方法,控制平行光束经过旋转毛玻璃耦合进入多模光纤的角度,达到抑制散斑和相干噪声的效果。通过理论推导和仿真模型构建,基于纤芯直径为1 mm的多模光纤扩展光源,在直径为25.4 mm的泰曼-格林干涉仪上进行了实验验证。结果表明:通过改变入射角度可以控制扩展光源的形态,在-3°~2°的入射角度范围内,干涉仪的信噪比最大值与正入射时相比提高了40.3%,此时入射角度处于纤端光斑形态发生变化的临界角度与正入射角度中间,且该临界值与理论推导和仿真结果一致。实验证明了所提方法可以抑制干涉仪的相干噪声。
Objective Defects such as scratches and dust on the surfaces of optical components in interferometers can generate diffraction ring coherent noise in interferograms,which can significantly affect measurement accuracy.To address this issue,this study introduces an extended-light-source method in which the coupling angle of a multimode fiber is altered.By controlling the coupling angle of the multimode fiber after the parallel beam passes through the rotating frosted glass,the proposed method effectively minimizes the effects of scattering and coherent noise.This approach provides a valuable contribution to the theory of extended light sources based on multimode fibers.The derivation and validation of the range of fiber incident angles at the location exhibiting the strongest signal-tonoise ratio(SNR)of the interferometric signal offer important guidance for installing and calibrating interferometers and other optical instruments utilizing this light-source configuration.Methods In this study,the objectives of eliminating coherent noise and improving the SNR of interference fringes in a composite extended source based on multimode fibers are explained.With a change in the coupling angle in the multimode fiber,the shape and size of the light beam emitted from the fiber end change accordingly.When the coupling fiber angle is adjusted,the free degree of the composite-light-source speckle increases,leading to a decrease in system speckle contrast.However,the size of the extended source affects the contrast of the interference fringes.Based on the formula for obtaining the interferometric SNR,it is known that changes in the scattering contrast and interference fringe contrast affect the SNR of the entire extended light source.In this study,the critical incident angle at which the light beam emitted from the fiber end becomes a hollow beam is derived through calculations.The Zemax OpticStudio software is used to simulate the fiber-end optical field.In the non-sequential mode,a Gaussian light source is set to enter at dif
作者
张徐
鲁棋
公维超
徐天柱
王微微
孙莹
刘世杰
Zhang Xu;Lu Qi;Gong Weichao;Xu Tianzhu;Wang Weiwei;Sun Ying;Liu Shijie(Precision Optical Manufacturing and Testing Center,Shanghai Institute of Optics and Fine Mechanics,Chinese Academy of Sciences,Shanghai 201800,China;University of Chinese Academy of Sciences,Beijing 100049,China;China-Russian Belt and Road Joint Laboratory on Laser Science,Shanghai 201800,China)
出处
《中国激光》
EI
CAS
CSCD
北大核心
2024年第6期179-188,共10页
Chinese Journal of Lasers
基金
国家重点研发计划(2020YFA0714500,2022YFE0204800)
中国科学院国际合作项目(181231KYSB20200040,2023VMB0008)。
关键词
光纤光学
干涉测量
扩展光源
相干噪声
信噪比
fiber optics
interferometry
extended light source
coherent noise
signal-to-noise ratio
