摘要
以聚对苯二甲酸乙二酯(PET)的塑料瓶胚零件为例,通过Moldflow软件设计浇注系统和冷却系统并进行有限元分析以优化零件的翘曲变形量。选定熔体温度、模具温度、保压压力、保压时间和注射时间为5个影响因素,设计了L16(45)的正交试验表。对正交实验数据进行了极差分析,得出了各因素对翘曲变形量的影响程度并获得较优工艺参数。通过GA-BP-PSO算法对工艺参数进一步优化,得到最佳工艺参数:熔体温度265℃、模具温度60℃、保压压力125 MPa、保压时间12.8671 s、注射时间0.3405 s。上述工艺参数对应的零件翘曲变形量为0.1373 mm。最后通过Moldflow软件进行数值模拟,得到翘曲变形量为0.1395 mm,较优化前的翘曲变形量0.1796 mm,降低了22.33%。软件模拟值和经GA-BP-PSO算法得到的预测值仅相差1.60%,将优化后的工艺参数组合应用于实际生产中,所获得的产品符合生产要求,验证了GA-BP-PSO算法的准确性与可行性。
Taking the plastic bottle preform made of polyethylene terephthalate(PET)as an example,the gating system and cooling system were designed by Moldflow software and finite element analysis was carried out to optimize the warping deforma‐tion of the workpiece.Five factors including melt temperature,mold temperature,holding pressure,holding time and injection time that influenced the warping deformation were identified,the orthogonal experiment table of L16(45)was designed,and the data were analyzed by range,so as to obtain the degree of influence of various factors on the amount of warpage and to obtain better process parameters.The process parameters were further optimized through the GA-BP-PSO algorithm,and the best process parameters are obtained:the melt temperature is 265℃,the mold temperature is 60℃,the holding pressure is 125 MPa,the holding time is 12.8671 s,the injection time is 0.3405 s.The warping deformation of the workpiece corresponding to the above process parameters is 0.1373 mm.Finally,the numerical simulation was carried out by Moldflow software,and the warpage deformation is 0.1395 mm,which is 22.33% lower than the warpage deformation before optimization of 0.1796 mm.The difference between the software simu‐lation value and the predicted value obtained by the GA-BP-PSO algorithm is only 1.60%,and the optimized process parameter combination is applied to actual production.The obtained products meet the production requirements,verify the accuracy and feasi‐bility of the GA-BP-PSO algorithm.
作者
陈忠杭
胡燕海
沈加明
倪德香
王舟挺
CHEN Zhonghang;HU Yanhai;SHEN Jiaming;NI Dexiang;WANG Zhouting(Ningbo University,School of Mechanical Engineering and Mechanics,Ningbo 315211,China;Ningbo Hwamda Machinery Manufacturing Co.,Ltd.,Ningbo 315000,China)
出处
《工程塑料应用》
CAS
CSCD
北大核心
2024年第3期70-75,共6页
Engineering Plastics Application
基金
国家自然科学基金项目(51705263)
