摘要
针对8磁极电磁轴承容错控制问题,文中提出了一种基于磁通等效的电磁轴承容错控制方法。该方法首先通过仿真得到磁通的电流-磁通影响系数,利用线性代数理论计算得到电流分配矩阵。当某一个磁极回路发生故障时,利用电流分配矩阵计算重构电流,使8个磁极端面的磁通在故障前后保持不变,即磁通等效,从而实现容错运行。在ANSYS有限元仿真平台进行仿真,用磁通等效方法可以较好地还原故障前的端面磁通和磁力线分布,并计算得到了磁通误差(最大不超过3.2%,绝大部分小于0.5%)和力误差(最大不超过7%,绝大部分小于1.5%),证明了所提出磁通等效容错控制方法的有效性。
In view of the problem of fault-tolerant control of 8-pole electromagnetic bearings,a fault-tolerant control method of electromagnetic bearings based on flux equivalence is proposed in the present study.The method first obtains the current-flux influence coefficient of magnetic flux by simulation,and uses linear algebra theory to calculate the current distribution matrix.When a fault occurs in one pole circuit,the current distribution matrix is used to calculate the reconfiguration current so that the flux at the end surfaces of the eight poles remains the same before and after the fault,that is,the flux is equivalent,thus achieving fault-tolerant operation.The simulation is carried out in ANSYS finite element simulation platform,and the flux equivalent method can restore the flux and magnetic force line distribution at the end face before the failure,and the flux error(the maximum does not exceed 3.2%,and most of them are less than 0.5%)and force error(the maximum is not more than 7%,and most of them are less than 1.5%)are calculated,which proves the effectiveness of the proposed flux equivalent fault tolerance control method.
作者
朱芳甫
陈亮亮
蒋科坚
ZHU Fangfu;CHEN Liangliang;JIANG Kejian(School of Information Science and Technology,Zhejiang Sci-Tech University,Hangzhou 310018,China;School of Information Engineering,Nanchang Hangkong University,Nanchang 330063,China)
出处
《电子科技》
2023年第2期37-45,共9页
Electronic Science and Technology
基金
国家自然科学基金(11272288,12062014)。
关键词
电磁轴承
电流-磁通影响系数矩阵
容错控制
磁极故障
磁通等效
电流分配矩阵
重构电流
等效误差
electromagnetic bearings
current-flux influence coefficient matrix
fault-tolerant control
pole fault
flux equivalence
current distribution matrix
reconfiguration current
equivalence error
