期刊文献+

长纤维增强聚合物注塑件翘曲变形数值模拟 被引量:3

Numerical Simulation on Warpage Deformation of Long-Fiber-Reinforced Polymer Injection-Molded Parts
下载PDF
导出
摘要 基于长纤维增强聚合物注塑件的纤维分布,运用Mori-Tanaka复合材料性能均质化理论模型,采用耦合有限元方法,分别建立了长纤维增强聚合物材料的弹性、弹塑性本构关系,研究了材料本构对翘曲变形模拟结果的影响程度,分析了主要纤维参数对翘曲变形的影响规律。结果表明,基于弹性、弹塑性材料本构的翘曲变形形状均为"穹顶"结构,但弹塑性本构的翘曲变形更大;翘曲变形随初始纤维长度、初始纤维长径比及纤维含量的增加而减小。 Based on the fiber distribution of long-fiber-reinforced polymer injection-molded parts,the elastic and elastoplastic constitutive models of long-fiber-reinforced polymer were established by using the Mori-Tanaka homogenization theory model of composite mechanical properties.The influence of material constitutive models on the warpage deformation was studied by the coupled finite element method,and the influence of main fiber parameters on the warpage deformation was analyzed as well.The results show that both the elastic and elastoplastic constitutive models have dome-shaped structures,but the warpage deformation of the elastoplastic constitutive model is larger than that of the elastic constitutive model;with the increase of initial fiber length,the initial fiber aspect ratio,and fiber content,warpage deformation decrease accordingly.
作者 江青松 柳和生 Qingsong Jiang;Hesheng Liu(Jiangxi Province Engineering Research Center of New Energy Technology and Equipment,East China University of Technology;School of Mechanical and Electronic Engineering,East China University of Technology,Nanchang 330013,China)
出处 《高分子材料科学与工程》 EI CAS CSCD 北大核心 2021年第10期126-131,共6页 Polymer Materials Science & Engineering
基金 东华理工大学博士基金(DHBK2019172) 江西省新能源工艺及装备工程技术研究中心开放基金(JXNE2021-06) 江西省重点研发计划(20203BBE53065)。
关键词 长纤维增强聚合物 注塑件 材料本构模型 纤维参数 翘曲变形 long-fiber-reinforced polymer injection-molded parts material constitutive model fiber parameters warpage deformation
  • 相关文献

参考文献4

二级参考文献49

共引文献40

同被引文献39

引证文献3

二级引证文献2

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部