摘要
变速器圆锥轴承在选垫过程需要测量圆锥轴承高度,测量机测量圆锥轴承时存在圆锥轴承端面倾斜的情况。研究表明,通过增加中心顶针可以控制圆锥轴承内圈倾斜,通过测量软件控制测量头的高度差可以控制圆锥轴承外圈倾斜夹角,可以有效地避免测量误差。
Transmission taper bearing in selected pad process need to measure the cone bearing height,measuring machine exists when measuring cone bearing cone bearing face declining situation.Studies have shown that,by increasing the center cone bearing inner ring tilt,thimble can control through software control measurement head height difference can control cone bearing outer ring tilt Angle,can effectively avoid the error of measurement.
作者
梁华锋
莫国田
Liang Huafeng;Mo Guotian(SAIC-GM-Wuling Automobile Co.Ltd.,Guangxi Liuzhou 545007;SAIC Liuzhuo Automobile Transmission Co.Ltd,Guangxi Liuzhou 545006)
出处
《南方农机》
2021年第12期184-186,189,共4页
关键词
圆锥轴承
测量
倾斜
平均值
Taper bearing
Measurement
Tilt
Average
