摘要
采用热力循环三维构建方法作为功冷并供系统的优化策略,分析了非共沸工质的组分特性对喷射式功冷并供系统性能的影响。对考虑工质组分质量分数变化的三维热力循环与传统二维热力循环系统性能进行对比。结果表明:采用热力循环三维构建方法可以使系统性能明显提高;蒸发温度为413.15 K时,系统增加分离器后热效率从33.2%提升到35.25%。
Using the three-dimensional(3 D) construction method of thermodynamic cycle as an optimization strategy for a combined power and ejector-refrigeration system, the effects of the composition of non-azeotropic working fluid on the performance of the combined system were analyzed, while a comparison was conducted between the performance of a 3 D thermal cycle system that takes into account the changes in the composition of the working fluid and that of a traditional 2 D thermal cycle system. Results show that the 3 D construction method of thermodynamic cycle can significantly improve the performance of the combined power and ejector-refrigeration system. When the evaporation temperature is 413.15 K, the thermal efficiency of the system would increase from 33.2% to 35.25%, after a separator is added to regulate the components.
作者
涂岱昕
张晓林
张强
许伟聪
夏宏伟
TU Daixin;ZHANG Xiaolin;ZHANG Qiang;XU Weicong;XIA Hongwei(Tianjin University Research Institute of Architectural Design and Urban Planning Co.,Ltd.,Tianjin 300073,China;Key Laboratory of Efficient Utilization of Low and Medium Grade Energy,Ministry of Education,Tianjin University,Tianjin 300072,China;Beijing Therma Technology Co.,Ltd.,Beijing 100084,China)
出处
《动力工程学报》
CAS
CSCD
北大核心
2021年第1期79-84,共6页
Journal of Chinese Society of Power Engineering
关键词
喷射式功冷并供系统
非共沸工质
有机朗肯循环
三维构建方法
combined power and ejector-refrigeration system
non-azeotropic working fluid
organic Rankine cycle
3D construction method
