摘要
通过智能医疗监测设备采集数据并将数据通过网络发送到远程计算机,能够实现远程监控。本文通过采用模块化的设计方法,选用单片机处理采集数据,其中利用温度传感、发光二极管、光敏二极管等进行测量,获得相关数据后传输到远程计算机。研究发现,运用MSP430F449单片机调试和下载程序时,主要是通过JTAG口完成的。在LABVIEW中设计上位机时,由于没有W5100而无法与电脑进行通信,因此在LABVIEW平台中加入了随机数,这样上位机的界面便可以显示出数据。
Data are collected by intelligent medical monitoring equipment and sent to remote computer through network to realize remote prosecution.Therefore,through the use of modular design method,the selection of SCM to deal with the acquisition of data.Among them,temperature sensor,light-emitting diode and photosensitive diode are used for measurement,and relevant data are transmitted to the remote computer.Research found that MSP430F449 microcontroller debugging and downloading procedures,mainly through the JTAG port.When designing the upper computer in LABVIEW,since there is no W5100 to communicate with the computer,random Numbers are added in LABVIEW platform,so that the upper computer interface can display data.
作者
张毅
ZHANG Yi(Anhui Jianzhu University,Hefei 230000,China)
出处
《长春师范大学学报》
2020年第4期28-31,共4页
Journal of Changchun Normal University
关键词
参数监测
单片机
温度
脉搏
parameter monitoring
single chip microcomputer
temperature
the pulse
