期刊文献+

拟合法改正南极泄露误差最佳外扩边界的确定及其应用 被引量:1

Estimation and Application of Optimized Extending Range to Reduce Leakage Error in the Antarctic by Means of Fitting Method
下载PDF
导出
摘要 以GRACECSR Mascon为模拟数据,讨论边界外扩及外扩范围内海洋信号对拟合法改正南极泄露误差的影响。实验表明,仅考虑南极信号泄露时,拟合边界至少为南极海岸线外扩300km;当考虑外扩范围内的海洋信号对南极质量变化及其空间分布的影响时,最佳拟合边界为海岸线外扩100km。采用最佳外扩边界线利用拟合法估算的CSRRL05时变重力场模型的南极质量变化速率为-178.61Gt/a,其质量变化空间分布与Mascon模型一致性较好。 In this paper,we use GRACE CSR Mascom data to analyze the effect on the leakage error correctionof boundary expansion and ocean signal within the boundary by means of fitting method in the Antarctic.Simulated results show that the minimum extending range is 300 km,when only considering the leakage-out error from the Antarctic.The ocean signal in the expansion boundary has a significant influence on the Antarctic mass change,particularly for spatial distribution of the mass change along the coastline region.When considering the leakage-out error and the influence of the adjacent ocean signal,the experiment suggests that the optimized extending range is 100 km.Then,the optimized extending range is applied to the fitting method,and the trend of the Antarctic mass change derived from the GRACE CSR RL05 data is-178.61 Gt/a,which is in good agreement with the Mascom results.
作者 邱春洪 范东明 谷延超 赵鸿彬 宿春鹏 尹恒 QIU Chunhong;FAN Dongming;GU Yanchao;ZHAO Hongbin;SU Chunpeng;YIN Heng(Faculty of Geosciences and Environmental Engineering,Southwest Jiaotong University,West High-Tec Zone,Chengdu 611756,China;China Railway Eryuan Engineering Group Co Ltd,3 Tongjin Road,Chengdu 610031,China;State-Province Joint Engineering Laboratory of Spatial Information Technology of High-Speed Rail Safety,West High-Tec Zone,Chengdu 611756,China;School of Civil Engineering and Architecture,Southwest Petroleum University,8 Xindu Road,Chengdu 610500,China)
出处 《大地测量与地球动力学》 CSCD 北大核心 2019年第11期1127-1131,共5页 Journal of Geodesy and Geodynamics
基金 国家自然科学基金(41574018)~~
关键词 GRACE 南极 泄漏误差 拟合法 质量平衡 GRACE Antarctic leakage error fitting method mass balance
  • 相关文献

参考文献2

二级参考文献13

  • 1Wahr J, Molenaar M, Bryan F. Time Variability of the Earth's Gravity Field: Hydrological and Oceanic Effects and Their Possible Detection Using GRACE[J]. Journal of Geophysical Research: Solid Earth, 1998, 103 (BI2): 30 205-30 229. 被引量:1
  • 2Sean S, Wahr J. Methods for Inferring Regional SurfaceMass Anomalies from Gravity Recovery and Climate Experiment C GRACE) Measurements of Time- Variable Gravity [J]. Journal of Geophysical Research: Solid Earth, 2002,107CB9): ETG 3-1-ETG 3-13. 被引量:1
  • 3Chen J L, Wilson C R, Blankenship D D, et al. Antarctic Mass Rates from GRACE[J]. Geophysical Research Letters, 2006, 33(11): 156-185. 被引量:1
  • 4Chen J L, Wilson C R, Tapley B D. Contribution of lee Sheet and Mountain Glacier Melt to Recent Sea Level Rise [J]. Nature Geoscience, 2013, 6(7): 549-552. 被引量:1
  • 5Swenson S, Chambers D, Wahr J. Estimating Geocenter Variations from a Combination of GRACE and Ocean Model Output [J]. Journal of Geophysical Research: Solid Earth, 2008, 113(138): 194-205. 被引量:1
  • 6Cheng M, Tapley B D, Ries J C. Deceleration in the Earth's Oblateness[J]. Journal of Geophysical Research: Solid Earth, 2013, 118(2): 740-747. 被引量:1
  • 7Geruo A, Wahr J, Zhong S. Computations of the Viscoelastic Response of a 3-D Compressible Earth to Surface Loading: An Application to Glacial Isostatic Adjustment in Antarctica and Canada [J]. Geophysical Journal Intcrnational , 2013, 192(2): 557-572. 被引量:1
  • 8Zwally H J ,Giovinctto M B, Li J, et al. Mass Changes of the Greenland and Antarctic Ice Sheets and Shelves and Contributions to Sea-Level Rise: 1992-2002[J]. Journal of Glaciology, 2005, 51(175): 509-527. 被引量:1
  • 9Gunter B, Urban T, Riva R, et al. A Comparison of Coin- cident GRACE and ICESat Data over Antarctica[J]. J Geodesy, 2009.83(11):1051-1060. 被引量:1
  • 10Jacob T, Wahr J, Pfeffer W T, et a1. Recent Contributions of Glaciers and Ice Caps to Sea Lcvel Rise [J]. Nature. 2012.482(7386): 511-518. 被引量:1

共引文献2

同被引文献2

引证文献1

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部