期刊文献+

温度循环试验中试件表面结霜/露现象及舱内水分来源的实验研究 被引量:4

Experimental study of the condensation and identifiation of the moisture source during thermal cycling test
下载PDF
导出
摘要 温度循环试验中试件表面出现结露,会对试件造成损害。文章对典型温度循环舱内大热惯性试件的表面结露现象进行了实验研究:分析了舱内水分来源,并测量了舱内压力在空间和时间上的分布特征。结果表明:舱内压力随着温度的降低而降低,风机进风口的负压造成了舱外湿空气侵入舱内;而试验前舱内蒸发器表面存有的霜层,也是造成低温向高温的切换过程中舱内空气露点温度升高的重要原因。采用氮气流量控制,可有效维持舱内的正压,同时抑制升温阶段舱内空气露点温度的快速升高,规避试件表面结露的风险。 The condensation of the water vapor on the product surface in the thermal cycling test may cause irreversible damages in the electrical products.In this paper,the condensation is observed on the test sample with a large thermal inertia in a typical thermal cycling test chamber,and the source of the moisture is analyzed.It is shown that the pressure in the chamber drops with the decrease of the air temperature.The negative pressure at the fan inlet results in the infiltrating of the outside moist air into the test chamber.In addition,the frost layer on the evaporator in the air handling unit before the test is also an essential factor that levels up the dew point of the air in the test chamber during the temperature rise period.The nitrogen flow control can help maintain a positive pressure within the test chamber and effectively bring down the dew point temperature during the temperature rise period.
作者 马腾飞 李树鹏 吴儒亮 宋超 MA Tengfei;LI Shupeng;WU Ruliang;SONG Chao(Beijing Institute of Spacecraft Environment Engineering,Beijing 100094)
出处 《航天器环境工程》 2019年第5期468-474,共7页 Spacecraft Environment Engineering
关键词 温度循环试验 结露现象 水分来源 正压控制 祛湿 实验研究 thremal cycling test condensation phenomenon thermal cycling test experimental study dehumidification
  • 相关文献

参考文献4

二级参考文献25

  • 1中国人民解放军总装备部.GJB150.1-86 军用设备环境试验方法[S].北京:中国人民解放军总装备部,1986. 被引量:3
  • 2沈维道,郑佩芝,蒋淡安.工程热力学[M].高等教育出版社,1995. 被引量:1
  • 3张祉佑,石秉三.低温技术原理与装置[M].机械工业出版社,1981. 被引量:1
  • 4张祉佑,石秉三.制冷及低温技术(上册)[M].北京:机械工业出版社,1981. 被引量:1
  • 5Van Meerbeek B, Yoshihara K, Yoshida Y, et al. State of the art of self-etch adhesives [ J]. Dent Mater, 2011, 27 ( 1 ) : 17 - 28. 被引量:1
  • 6Van Meerbeek B, De Munck J, Yoshida Y, et al. Adhesion to enamel and dentin: current status and future challenges [ J]. Oper Dent, 2003, 28(3) : 215 -235. 被引量:1
  • 7Van Landuyt KL, Snauwaert J, Peumans M, et al. The role of HEMA in one-step self-etch adhesives [J]. Dent Mater, 2008, 24(10) : 1412 -1419. 被引量:1
  • 8Tay FR, Pashley DH, Yoshiyama M. Two modes of nanoleakage expression in single-step adhesives [Jl. J Dent Res, 2002, 81 (7) : 472 -476. 被引量:1
  • 9De Munck J, Van Landuyt K, Peumans M, et al. A critical re- view of the durability of adhesion to tooth tissue : methods and re- suits [J]. J Dent Res, 2005, 84(2) : 118 -132. 被引量:1
  • 10LeloupG, D' hoore W, Bouter D, et al. Meta-analytical review of factors involved in dentin adherence [J]. J Dent Res, 2001, 80 (7) : 1605 -1614. 被引量:1

共引文献16

同被引文献34

引证文献4

二级引证文献5

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部