期刊文献+

氟化石墨材料的改性及其电化学性能研究 被引量:4

Modifications and Electrochemical Properties of Graphite Fluoride
下载PDF
导出
摘要 本文以商用氟化石墨为原料,通过水合肼还原的方法对氟化石墨(CFx)进行改性处理,系统研究了不同水合肼用量对材料电化学性能的影响.采用XRD、SEM、EDS、XPS、交流阻抗(EIS)和恒流放电测试技术,对改性氟化石墨材料的物相及电化学性能进行了分析研究.结果表明,采用改性氟化石墨材料制备的锂/氟化碳(Li/CFx)电池的电压滞后现象得到明显改善,且不同水合肼用量对材料的电化学性能有重要影响.H-CFx-2(CFx:C2H6O:N2H4·H2O的比例为1:2:1)材料的综合性能最佳,在0.1C倍率下,材料的克比容量达到794.5 m Ah·g-1,平台电压为2.53V,电压滞后现象的低波电压为2.37 V. The commercial fluorinated graphite(CFx) was used as the raw material, which was modified by the reduction of hydrazine hydrate(N2 H4·H2 O). The effects of hydrazine hydrate contents on the electrochemical properties of fluorinated graphite were systematically studied. The crystal phases and electrochemical properties of the modified fluorinated graphite were analyzed by XRD, SEM, EDS, XPS, EIS techniques and constant current discharge measurement. The results showed that the voltage hysteresis response of Lithium-fluorocarbon battery prepared by the modified fluorinated graphite was obviously improved, while the amount of hydrazine hydrate had an important influence on the electrochemical performance of the materials.The H-CFx-2 material had the best overall performance(CFx:C2 H6 O:N2 H4·H2 O was 1:2:1). At 0.1 C, the specific capacity of the material reached 794.5 m Ah·g-1, the platform voltage was 2.53 V, and the low-wave voltage of the voltage hysteresis was 2.37 V.
作者 张亮 张红梅 万伟华 魏俊华 ZHANG Liang;ZHANG Hong-mei;WAN Wei-hua;WEI Jun-hua(State Key Laboratory of Advanced Chemical Power Source,Gui Zhou Mei Ling Power Sources Co.Ltd,Zunyi 563003,Guizhou,China)
出处 《电化学》 CAS CSCD 北大核心 2018年第4期385-391,共7页 Journal of Electrochemistry
关键词 锂/氟化碳电池 氟化石墨 水合肼 改性 lithium-fluorocarbon battery fluorinated graphite hydrazine hydrate modification
  • 相关文献

参考文献3

二级参考文献35

  • 1吕鸣祥.化学电源[M].天津:天津大学出版社,1996.14-40. 被引量:9
  • 2Ajayan P M. Capillarity-induced filling of carbon nanotubes[J]. Nature, 1993, 361: 333. 被引量:1
  • 3Iijima S. Helical microtubules of graphitic carbon[J]. Nature, 1991, 354: 56~58. 被引量:1
  • 4Wu Shenghui, You Jinkua,Lin Zugeng. Study on Carbon Nanotubes as an Anode Materials for Lithium Ion Battery, Abstrast, 5: 2-6 [C]. USA: 50th ISE, 195nd ECS Joint Meeting, Seattle, 1999. 被引量:1
  • 5陈萍,张鸿斌,林国栋,et al. The transition metal catalyst and the method for preparing CNT[P]. China Pat:Appl. No 96 1 10252.7,1996. 被引量:1
  • 6Wang C S, Wu G T, Zhang X B, et al. Lithium insertion in carbon-silicon composite materials produced by mechanical milling[J]. J.Electrochem.Soc., 1998, 145: 2 751. 被引量:1
  • 7吴升辉. Relation between configuration of carbon nanotube and performance of lithium intercalation[D]. Xiamen:Xiamen Univ., 2000. 被引量:1
  • 8Li Hong, Wang Qing, Shi Lihong, et al. Nanosized SnSb alloy pinning on hard non-graphitic carbon spherules as anode materials for a Li ion battery[J]. Chem. Mater, 2002, 14: 103~108. 被引量:1
  • 9Kim D G, Kim H, Sohn H J, et al. Nanasized Sn-Cu-B alloy anode prepared by chemical reduction for secondary lithium batteries[J]. J.Power Sources, 2002, 104: 221~225. 被引量:1
  • 10THACKERAY M M. Manganese oxides for lithium batteries [J].Solid State Chem,1997,25:1-71. 被引量:1

共引文献11

同被引文献74

引证文献4

二级引证文献23

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部