摘要
该文应用大涡模拟方法研究不同孔隙度透过性沙障嵌固端受力变化及其周围流场结构特征。结果表明,非透过沙障在相同速度的促发气流下嵌固端受力远高于孔隙沙障,其嵌固端弯矩和剪力最大值分别为40%孔隙率沙障的2倍和1.5倍,为80%孔隙率沙障的16.5倍和14.45倍,沙障嵌固端最大弯矩和剪力值随孔隙率增大而逐渐减小。在持续风力作用下,沙障嵌固端所受弯矩和剪力大大降低,沙障孔隙率为0时,其最大弯矩和剪力值约为其平均值的9.4倍和6.9倍,而沙障孔隙率为80%时,最大弯矩和剪力值分别约为其平均值的2.3倍与2.5倍。沙障孔隙度在一定范围内变化时,其周围流场结构有一定的相似性,以50%孔隙率为分界点可以分为2组,每组沙障嵌固端受力各有其相似的变化特征。研究可为沙障设计插入深度提供理论支撑。
Inserted depth is an important parameter in sand fence engineering. In order to provide a theoretical support for inserted depth of sand fence, the sand fence with different porosity was studied by using LES method. Five kinds of sand fence were selected as the research objects with the porosity of 0, 20%, 40%, 60% and 80%. The height of sand fence was 50 mm. Boundary condition was of great importance to the simulation of the flow structure around the sand fence, the large eddy model（LES） was employed as the turbulence model. The gas phase had been simplified with the influence of sand particles ignored. It was treated as incompressible gas, and its flow was assumed to be in transition state. The velocity at inlet of calculation domain followed the logarithm distribution and the friction velocity was 0.5 m/s. The SIMPLIC method was employed for flow field prediction. Ten layers were arranged near wall and the height of the first layer was 0.01 mm, and yplus was less than 1. The top boundary of calculation domain was slip wall boundary, and the bottom was nonslip wall boundary. The turbulence numerical results for sand fence with the porosity 0 were compared with the experimental results of a similar study that was conducted in a blowing sand wind tunnel at the Key Laboratory of Desert and Desertification of Chinese Academy of Sciences. The particle image velocimetry（PIV） was employed to determine mean velocity and the turbulence fields were calculated by the velocity. The numerical model was well verified. Then, the variation of bending moment and shear force with porosity and the flow structure around the fence were analyzed. The results showed that the bending moment and shear force on the embedded end of sand fence without pores was much higher than that for the sand fence with pores under the sudden air flow with same velocity, and its maximum bending moment and shear force on the embedded end were 2 and 1.5 times of that with 40% porosity, and were 16.5 and 14.45 times of that with 80% porosity. The
作者
孙浩
刘晋浩
黄青青
Sun Hao Liu Jinhao Huang Qingqing(School of Technology, Beo＇ing Forestry University, Beijing 100083, China)
出处
《农业工程学报》
EI
CAS
CSCD
北大核心
2017年第2期148-154,共7页
Transactions of the Chinese Society of Agricultural Engineering
基金
国家科技支撑计划项目-林业生态科技工程(2015BAD07B00)
关键词
孔隙度
流场结构
数值方法
透过性沙障
大涡模拟
固沙
porosity
flow structure
numerical methods
porous fences
large eddy simulation
sand fixation
