期刊文献+

淬火后预拉伸对自然时效状态Al-Li合金组织和性能的影响 被引量:9

EFFECT OF PREAGED STRETCH AFTER QUENCHED ON THE PROPERTIES AND MICROSTRUCTURE OF A NATURALLY AGED Al-Li ALLOY
原文传递
导出
摘要 通过拉伸试验机、腐蚀试验箱、DSC以及TEM等手段对淬火后预拉伸处理并自然时效至稳定状态的铝锂合金薄板的拉伸性能、腐蚀性能、时效响应特征以及微观组织进行了研究.结果表明,在0~6%范围内,合金的屈服强度随预拉伸量的增加而逐渐提高;预拉伸量低于3%时,合金的抗拉强度随拉伸量增加逐渐降低,在3%~6%范围内,抗拉强度趋于平稳;随预拉伸量增加,合金由明显的晶问腐蚀转为点蚀,T34状态点蚀深度最小,约为0.03mm;预拉伸改变了合金的时效响应特征,使合金在100℃附近的吸热峰向高温移动,180℃及260℃附近的放热峰向低温区移动.淬火后的预拉伸在增加晶内位错密度的同时,抑制了δ'相在晶内和晶界的析出,预拉伸量越大,晶内及晶界δ'相的数量越少.位错及析出相的共同作用影响了合金的拉伸及腐蚀性能. Al-Cu-Li-X alloy has attractive applications in the aerospace and aeronautic industry due to its ex- cellent combination of mechanical properties and corrosion resisting properties. However, the microstructural com- plexity, especially the type and distribution of precipitates have effects on the properties. Besides changing the chemical compositions of alloy, the preaged stretch after quenched and aging process is the main method to control the type and distribution of precipitates. In this work, the effect ofpreaged stretch after quenched on tensile proper- ties, corrosion property, aging response and microstructure of a naturally aged Al-Li alloy were studied by DSC, TEM, tensile test and corrosion test. The results show that the yield strength increases gradually at the stretch range from 0 to 6%, ultimate tensile strength decreases with the increase of stretch from 0 to 3%, and then become stable when stretch over 3%. Accompany with the increasing stretch, the corrosion type of alloy changes from intergranu- lar corrosion to point corrosion. The T34 state of alloy has the least corrosion depth, about 0.03 mm. The aging re- sponse character of alloy is changed by preaged stretch. Compared with T4 state, the endothermic peak near 100 ℃ move to higher temperature, and two exothermic peaks near 180 ℃ and 260 ℃ move to lower temperature in T3xstate, respectively. Preaged stretch after quenched restrains the precipitation of δ' phase in grain and grain boundary with increasing the density of dislocation in grains. The variations of δ' phase and dislocation affect the tensile and corrosion properties of alloy.
出处 《金属学报》 SCIE EI CAS CSCD 北大核心 2016年第12期1497-1502,共6页 Acta Metallurgica Sinica
基金 国家自然科学基金资助项目51474195~~
关键词 铝锂合金 预拉伸处理 拉伸性能 晶间腐蚀 δ'析出相 Al-Li alloy preaged stretch tensile property intergranular corrosion δ' precipitate
  • 相关文献

参考文献2

二级参考文献14

  • 1邱惠中.铝锂合金的发展概况及其应用[J].宇航材料工艺,1993,23(4):38-45. 被引量:43
  • 2ФридлядерИН,ШиряеваНВ.Фазовыйсостави.механичскиесвойствасплавовалюминиясмагниемилитием[J].Металы,1965,(2):153-157. 被引量:1
  • 3ШнекйлерГЛ,ШевелеваЛМ,КапушкинЕЯ.ФазовыепревращенияпритермическойобработкЕсплава 1420[J].Цветныеметаллы,1994,(2):49-52. 被引量:1
  • 4RINKER G J,MAREK M.New light alloys of Al-Li-Mg[J].Materials Science and Engineering,1984,(6) 4:203-207. 被引量:1
  • 5DEJONG H F.A survey of the development properties and application of Al-Li Alloys[J].Aluminum,1984,(9):673-679. 被引量:1
  • 6SHEPPARD T,PARSON N C.Corrosion resistance of Al-Li alloys[J].Materials Science and Technology,1987 (3):341-352. 被引量:1
  • 7许鹤鸣,何德茂.金属热处理[M].北京机械工业出版社,1989. 被引量:1
  • 8贺国芳.可靠性数据的收集与分析[M].北京:国防工业出版社,1991. 被引量:1
  • 9许鹤鸣,何德茂.有色金属及热处理[M].北京:国防工业出版社,1980. 被引量:1
  • 10夏德顺.国外铝锂合金工艺性研究[J].航天工艺,1998(4):26-40. 被引量:5

共引文献7

同被引文献63

引证文献9

二级引证文献20

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部