An Experimental Investigation of Glass Transition Temperature of Composite Materials Using Bending Test
An Experimental Investigation of Glass Transition Temperature of Composite Materials Using Bending Test
摘要
In this study, the bending test is used to investigate the glass transition temperature for epoxy reinforced with three types ot fibers, fiberglass, Kevlar and synthetic wool, these materials have a wide used in many application which they are used composite materials. The glass transition temperature can be measured at the point of inflection for "the curve of variation of the deflection and temperature. The results show that, the glass transition temperature is affected by the type of the reinforcement of the composites. On the other hand, the glass transition temperature of the wool composite is higher than the other.
参考文献8
-
1Kaj, B., Rob, H., Petrilhalainen, P. S., Nick, T., and Jouko, P. 2007. "Determination of the Glass Transition Temperature of Latex Films: Comparison of VariousMethod." Polymer Testing 26 (8): 1031-40. 被引量:1
-
2Bryan, H. 1999. Engineering Composite Materials. London: The Institute of Materials. 被引量:1
-
3Dillip, K. P., Choudhary, R. N. P., Samantaray, B. K., Karan, N. K., and Katiyar, R. S. 2007. "Effect of Plasticizer on Structural and Electrical Properties of Polymer Nanocompsoite Electrolytes." Int. J. Electrochem. Sci. 2 (October): 861-71. 被引量:1
-
4Sanjay, N. K., Agat'wal, A. V., and Sheoran, M. S. 2008. "Thermal and Electrical Properties of MoO3-Bi203-B203 Glasses." Indian Journal of Pure and Applied Physics 46 (October): 719 -21. 被引量:1
-
5Agroui, K., and Collins, G. 2013. "Thermal Relaxations and Transitions in EVA Encapsulant Material during Photovoltaic Module Encapsulation Process." In Materials and Processes for Energy: Communicating Current Research and Technological Developments, edited by M6ndez-Vilas, A. Badajoz: Formatex Research Center. 被引量:1
-
6Sujan, E. B. W. 2009. Dynamic Mechanical Analysis and Its Advantages for Deflection Temperature under Load Measurements. New Castle: TA Instruments. 被引量:1
-
7Gracia-Femhndez, C. A., Gomez-Barreiro, S., Lopez-Beceiro, J., Tarrio Saavedra, J., Naya, S., and Artiaga, R. 2010. "Comparative Study of the Dynamic Glass Transition Temperature by DMA and TMDSC." Polymer Testing 29 (8): 1002-6. 被引量:1
-
8Mei, Z., and Chung, D. D. L. 2000. "Glass Transition and Melting Behavior of Carbon Fiber Reinforced Thermoplastic Composite, Studied by Electrical Resistance Measurement." Polymer Composites 21 (5): 711-5. 被引量:1
-
1JIA Qingming ZHENG Maosheng SHEN Renjie CHEN Hongxiang.THE GLASS TRANSITION TEMPERATURE AND MICROSTRUCTURE OF POLYURETHANE/EPOXY RESIN INTERPENETRATING POLYMER NETWORKS NANOCOMPOSITES[J].Chinese Science Bulletin,2006,51(3):293-298. 被引量:7
-
2Fu Xu,Xiaolong Mo,Sen Wan,Changqing Jiang,Hongwei Hao,Luming Li.High-performance flexural fatigue of carbon nanotube yarns[J].Chinese Science Bulletin,2014,59(29):3831-3834. 被引量:3
-
3侯万国.SYNTHESIS AND PROPERTIES OF POLYSTYRENE/LAPONITE NANOCOMPOSITES[J].Chinese Journal of Polymer Science,2004,22(5):459-462.
-
4L.Ren, K.Tsuru, S.Hayakawa and A.Osaka Biomaterial Laboratory, Faculty of Engineering, Okayama University, Tsushima 3-1-1, Okayama-shi 700-8530, Japan E-mail: osaka@cc.okayama-u.ac.jp.Viscoelastic Properties and Bioactivity of Sol-Gel Derived Gelatin-Silicate Composites: Effects of the Incorporated Ca^(2+) Ions[J].Journal of Materials Science & Technology,2001,17(3):367-370.
-
5陈彤.全国玻璃纤维标准化技术委员会二届三次年会暨标准审议会会议纪要[J].玻璃纤维,2005(6):41-42.
-
6PTFE/GE混纺滤材项目通过专家鉴定[J].企业科技与发展,2009(11):6-6.
-
7SHENG Yan-zhen,YANG Hua,LI Jun-yin,SUN Miao.Predicting Glass Transition Temperature of Polyethylene/Graphene Nanocomposites by Molecular Dynamic Simulation[J].Chemical Research in Chinese Universities,2013,29(4):788-792. 被引量:4
-
8GUO Tong,LI AiQun,SONG YongSheng,ZHANG Biao,LIU Yang,YU NingSheng.Experimental study on strain and deformation monitoring of reinforced concrete structures using PPP-BOTDA[J].Science China(Technological Sciences),2009,52(10):2859-2868. 被引量:8
-
9陈文.碳泡沫及石墨泡沫在航空上的应用[J].航空维修与工程,2005(3):33-35. 被引量:9
-
10危良才.国内外玻纤制品生产现状及发展动向[J].印制电路信息,2005(4):33-39. 被引量:1