摘要
首先采用Pro/E绘图软件对一种常见三通管塑件进行三维造型,然后运用Moldflow对比了不同浇注系统对该塑件成型质量的影响,并优化了工艺参数,从而得到较好的浇注系统方案。结果表明:通过浇注系统分析及工艺参数优化,有效缩短了模具设计周期,同时得到合格的塑料三通管产品。
The 3D modeling of a common plastic T-branch pipe was engaged by Pro/E software,then the effects of different pouring system on the quality of the plastic part were compared by Moldflow software,and the process parameters were optimized,thus a good scheme of gating system could be obtained.The results show that：through the pouring system analysis and the optimization of process parameters,the design cycle of the mould can be shortened effectively,and the qualified plastic parts can be produced.
出处
《塑料科技》
CAS
北大核心
2016年第1期83-86,共4页
Plastics Science and Technology
基金
江苏省高校自然科学研究项目(13KJD430002)
