摘要
利用熔融挤出法制备了聚酰胺1010(PA1010)/氯化锌(ZnCl2)复合材料,研究了ZnCl2的含量对PA1010/ZnCl2复合材料的结晶行为、力学性能、光学性能的影响。结果表明:随着ZnCl2含量的增加,PA1010/ZnCl2复合材料的结晶不完善程度增大,熔点降低。另外,PA1010/ZnCl2复合材料的拉伸强度随着ZnCl2含量的增加逐渐增大,当ZnCl2含量为8%时,复合材料的拉伸强度达到最大值66.2 MPa,与PA1010(52.2 MPa)相比提高了26.7%。当ZnCl2含量为8%时,可以得到熔点较低,力学性能优良和透光率较好的PA1010/ZnCl2复合材料。
The polyamide-1010（PA1010）/zinc chloride（ZnCl2） composites were prepared through melting extrusion method, and the effect of the content of ZnCl2 on the crystallization behavior, the mechanical properties and optical properties of PA1010/ZnCl2 composites were researched. The results show that： with the increase of the content of ZnCl2, the imperfect crystallization degree of PA1010/ZnCl2 increases and the melting temperature decreases. In addition, the tensile strength of PA1010/ZnCl2 composites significantly increases with the increasing of ZnCl2 content. When ZnCl2 content is 8%, the tensile strength of PA1010/ZnCl2 composites reaches to maximum（66.2 MPa）, which increases by 26.7% comparing with PA1010（52.2 MPa）. PA1010/ZnCl2 composites which have lower melting point, excellent mechanical properties and light transmittance can be obtained when the content of ZnCl2 is 8%.
出处
《塑料科技》
CAS
北大核心
2014年第9期31-34,共4页
Plastics Science and Technology
基金
贵州省教育厅研究生卓越人才计划项目(黔教研合ZYRC字[2013]006号)
贵州省优秀青年科技人才培养对象专项资金项目
黔科合人字(2013)33号
关键词
聚酰胺1010
氯化锌
力学性能
结晶性能
光学性能
Polyamide-1010
Zinc chloride
Mechanical properties
Crystallization properties
Optical properties
