摘要
利用销盘式磨损试验机研究了粉末冶金法制备的多壁纳米碳管 /Cu基复合材料的稳态摩擦磨损行为 ,并用扫描电镜分析了复合材料的磨损形貌。结果表明 :多壁纳米碳管 /Cu基复合材料具有较小的摩擦系数 ,并随纳米碳管质量分数的增加而逐渐降低 ;由于复合材料中纳米碳管的增强和减摩作用 ,在低载荷和中等载荷作用下 ,随着纳米碳管质量分数的增加 ,复合材料的磨损率减小 ;而在高载荷作用下 ,由于发生表面开裂和片状层剥落 ,含纳米碳管质量分数高的复合材料的磨损率增高。
The friction and wear behavior of multi walled carbon nanotube/Cu matrix composites fabricated by powder metallurgy were investigated using a pin on disk test rig under steady state conditions and the worn surfaces were analyzed by scanning electron microscopy (SEM). The experimental results indicated that the coefficients of friction for the composites are low and decreased with the carbon nanotube content increasing. At lower and intermediate loads, the wear rate of the composites decreases with increasing the carbon nanotube content due to the effect of reinforcement and reduced friction. Because the surface fracture and fragment of the flake layer occur at higher load, the composites with high carbon nanotube content exhibit reduced wear resistance. [
出处
《中国有色金属学报》
EI
CAS
CSCD
北大核心
2001年第3期367-371,共5页
The Chinese Journal of Nonferrous Metals
基金
国家自然科学基金资助项目 ( 5 9872 0 3 0 )和 ( 2 0 0 0 3 0 0 9)
教育部留学回国人员科研启动基金资助项目
关键词
多壁纳米碳管
金属基复合材料
摩擦系数
磨损率
multi walled carbon nanotube
metal matrix composite
coefficient of friction
wear rate
