摘要
目的:通过使用灭菌装载专用分隔架合理摆放纸塑单包装物品,避免压力蒸汽灭菌后纸塑单包装物品湿包现象的产生。方法:将纸塑单包装物品随机分为对照组和实验组,各1 500件。对照组:将纸塑物品竖放于标准篮筐内,纸面对塑面,包与包之间互相挨靠;实验组:用小支架隔开纸塑单包装物品,留有3 cm的间隙,包与包之间放置一块吸水巾,最后放入灭菌专用篮筐中。灭菌结束后观察湿包情况。结果:通过计算,对照组和实验组湿包率分别为20.33%和0.4%,2组数据相比,差异有统计学意义(P﹤0.01)。结论:实行此项措施后,纸塑单包装物品湿包现象显著减少,确保了灭菌合格率,提高了纸塑单包装物品的灭菌效果。
Objective To store paper-plastics packing items in a specific sterile shelf to eliminate the phenomenon of pack getting wet after pressuresteam sterilization. Methods Totally 3 000 pieces of paper-plastics items were divided equally into an experiment group and a control group. In the control group, the items were put vertically in standard basket, with the paper surface facing the plastics surface and the packs leaning on each other. In the experiment group, the items were separated by some bracket with 3 cm interspace and an absorbent sheet between two items, and then put into the specific basket. The rate for the pack getting wet was observed. Results The rates were 20.33% and 0.4% respectively in the control group and experimental group, and there was significant difference between the rates, with P〈 0.01. Conclusion The phenomenon of pack getting wet is reduced, and the disinfecting effect of paper-plastics packing items is enhanced greatly.
出处
《医疗卫生装备》
CAS
2014年第4期50-51,共2页
Chinese Medical Equipment Journal
关键词
灭菌装载专用分隔架
装载
纸塑单包装物品
湿包
吸水巾
specific sterile shelf
loading
paper-plastics packing item
wet pack
absorbent sheet
