摘要
在经磷酸(PA)处理的芳纶(AF)表面上涂覆环氧树脂(EP)和固化剂(2E4MZ),用极性端基液体橡胶(LIR)作为EP与天然橡胶(NR)的相容剂,改善AF与NR的界面,并用母炼胶法制备了AF/NR复合材料。通过与NR和单一用磷酸处理AF的复合材料的性能对比发现,AF经过EP和2E4MZ改性后,AF/NR复合材料的硫化速度和交联程度均提高;拉伸强度、撕裂强度和300%定伸应力都显著增强,且当m(EP)/m(AF)为7/100时最佳。动态力学性能测试(DMA)结果表明,EP/2E4MZ处理AF的天然胶具有更高的储能模量和损耗模量;扫描电镜(SEM)分析表明,AF/NR的拉伸断面粗糙,EP和2E4MZ能改善AF与NR的界面粘接。
Aramid fiber（AF） was modified with epoxy resin（EP） and curing agent 2-ethyl-4-methylimidazole （2E4MZ） via surface coating on the basis of the treatment with phosphorous acid solution. Liquid imprene rubber （L1R） was regard as compatibilizer between EP and NR. AF/NR composites were prepared through masterbatch method. The deep-going modified AF not only accelerated the vulcanization of NR composites, but also enhanced the mechanical properties of AF/NR composites such as the tensile strength and the tear strength. When m （EP）/m （AF） is 7/100, comprehensive properties of vulcanized AF/NR are the best. The results of dynamic mechanical analysis （DMA） reveal that AF/NP, composites have higher storage modulus and loss modulus after AF was treated with EP and 2E4MZ. Scamfing electron microscopy （SEM） photos show that the tensile fracture of AF/NR composites becomes rough, implying that the bonding strength in interface is improved with the addition of EP and 2E4MZ.
出处
《高分子材料科学与工程》
EI
CAS
CSCD
北大核心
2013年第12期77-81,共5页
Polymer Materials Science & Engineering
基金
贵州省橡胶重大专项(2013)
关键词
芳纶纤维
天然橡胶
环氧树脂
母炼胶
动态固化
界面粘接
aramid fiber
natural rubber
epoxy
masterbatch
dynamically cured
interracial adhesion
