摘要
以椰子油脂肪酸(CFA)和季戊四醇(PE)为原料,对甲苯磺酸为催化剂,甲苯为带水剂,通过回流分水酯化法合成椰子油脂肪酸季戊四醇酯。获得优化反应条件为:催化剂对甲苯磺酸用量3%(以反应物质量为基准),酸醇物质的量比4.4∶1,带水剂甲苯用量40%(以反应物质量为基准),反应温度150℃,反应时间3 h。在此优化条件下,酯化率为97.2%。产物结构经FT-IR光谱证实为椰子油脂肪酸季戊四醇酯(四酯),产物的酸值(KOH)为0.62 mg/g,皂化值(KOH)为254.9 mg/g,可作为生产绿色酯类润滑油的基础油。
Coconut oil fatty acid pentaerythritol ester was prepared through the esterification of coconut oil fatty acid and pentaerythritol with p - toluene sulfonic acid as catalyst and toluene as water - entrainer. The optimal reaction conditions were as follows： catalyst dosage 3% （based on the mass of reactants）, molar ratio of coconut oil fatty acid to pentaerythritol 4.4：1 ,water - entrainer toluene dosage 40% （ based on the mass of reactants ） , reaction temperature 150℃ and reaction time 3 h. The esterification rate was 97.2% under the optimal reaction conditions, and the chemical structure of the esterification product was confirmed by FT - IR. The acid value and saponification value of the product were determined as 0.62 mgKOH/g and 254.9 mgKOH/g, respectively. The＇product could 15e used as base oil for green lubricants production.
出处
《中国油脂》
CAS
CSCD
北大核心
2013年第3期47-50,共4页
China Oils and Fats
基金
三亚市院地科技合作项目(2011YD12)
海南省自然科学基金项目(511117)
关键词
绿色润滑油
椰子油脂肪酸
季戊四醇
制备
green lubricant
coconut oil fatty acid
pentaerythritol
preparation
