期刊文献+

连续流状态下好氧颗粒污泥培养及其脱氮除磷性能研究 被引量:3

Cultivation and Characters of the Aerobic Granule Sludge for Simultaneous Nitrogen and Phosphorus Removal in the Continuous Flow Condition
下载PDF
导出
摘要 在上流式污泥床好氧颗粒污泥反应器中,以厌氧颗粒污泥为接种泥.采用人工配制的模拟废水为进水的条件下,成功培养出具有同步脱氮除磷的好氧颗粒污泥。颗粒污泥粒径在0.5~2mm,颗粒污泥沉淀速度在29~58m/h。MLSS为3077---4103mg/L。当COD的进水容积负荷为4.8kg/(m3·d)时,去除率高达96%以上。氨氮进水在160mg/L时,去除率达97%以上,出水氨氮在5mg/L以下。对总磷的去除率在22%-37%。主要是因为亚硝态氮浓度、COD/TN比和TN/TP比等对聚磷菌除磷有影响。 The successful cultivation of aerobic granular sludge used for simultaneous nitrogen and phosphorus removal in airlift aerobic granular sludge bed reactor(AGSB) which was inoculated anaerobic granular sludge and was performed using a synthetic wastewater mainly consisted of glucose as carbon source. The diameters of the granules were 0.5-2 mm, the settling velocity were 29-58 m/h, MLSS of 3077--4103 mg/L. As the COD loading of 4.8 kg/(m3.d)were employed, COD removal efficiency of above 96 %. When the ammonia nitrogen concentration of 160 mg/L was used as the influent to the reactor, the removal rate of ammonia nitrogen was 97 % and the ammonia nitrogen concentration of effluent was low as 5 mg/L The remove rate of TP was 22 %-37 %. The main reason was that the concentration of nitrite and the radios ofCOD/TN, TN/TP impact the TP removal efficiency.
出处 《广东化工》 CAS 2012年第7期26-28,共3页 Guangdong Chemical Industry
关键词 连续流 好氧颗粒污泥 同步脱氮除磷 continuous flow: aerobic granular sludge: simultaneous nitrogen and phosphorus removal
  • 相关文献

参考文献3

二级参考文献22

  • 1P. Walker. Wet Adhesion: The Continuing Debate[J]. JOCCA, 1986(4): 103. 被引量:1
  • 2Willard D. Bascom. Water at the Interface. J. Adhesion. 1970, 2(7): 161. 被引量:1
  • 3郭淑静,张秀梅.国内外涂料助荆产品手册[M].第2版,北京:化学工业出版社,2005:1-33. 被引量:1
  • 4Zeno W·戚克斯等著.经桴良,姜英涛等译,虞兆年校.有机涂料科学和技术[M].北京:化学工业出版社,2002:118—135. 被引量:1
  • 5R Lamboume and T A. Strivene. Paint and Surface Coatings. Theory and Practice. Woodhead Publishing Limited. 674. 被引量:1
  • 6D.Satas Arthur A.Tracton编.赵风清,肖纪君等译,耿耀宗,刘国杰审校.涂料涂装工艺应用手册[M].第2版. 被引量:1
  • 7V V Arslanov and V A Ogrey. Adhesive Joints of Light Metals With Polymers. Prag. Org. Coat. 1987(15): 1 - 31. 被引量:1
  • 8Edwin P. Plueddemann. Adhesion Throuth Silane Coupling Agents. J. Adhesion. 1970, 2 (7) : 184. 被引量:1
  • 9Edwin P. Plueddemann. Silane Adhesion Promoters in Coatings. Prog. Org. Coat. 1983 ( 11 ) : 297 - 303. 被引量:1
  • 10K. L. Mittal(ed). Adhesive Aspects of Polymeric Coatings. Plenum Press, NewYorkand London. 1983. 363. 被引量:1

共引文献18

同被引文献51

  • 1张岩,王永胜,白玉华,陈晨,吕鑑,张杰.泳动床/好氧颗粒污泥新技术处理生活污水的特性研究[J].环境科学,2007,28(10):2249-2254. 被引量:17
  • 2Adav S S, Lee D J, Show KY, et al. Aerobic granular sludge: Recent advances[J].BiotechnologyAdvances, 2008, 26 (5): 411-423. 被引量:1
  • 3Mishima K, Nakamura M. Self-Immobilization of aerobic activated sludge--A pilot study of the aerobic upflow sludge blanket process in municipal sewage treatment[J]. Water Science and Technology, 1991, 23: 981-990. 被引量:1
  • 4Liu Y, Tay J H. State of the art of biogranulation technology for wastewater treatment[J]. Biotechnology Advances, 2004, 22 (7): 533-563. 被引量:1
  • 5Lee D J, Chen Y Y, Show K Y, et al. Advances in aerobic granule formation and granule stability in the course of storage and reactor operation[J].BiotechnologyAdvances, 2010, 28 (6): 919-934. 被引量:1
  • 6Show K Y, Lee D J, Tay J H. Aerobic granulation: Advances and challenges[J]. Applied Biochemistry and Biotechnology, 2012, 167 (6): 1622-1640. 被引量:1
  • 7Liu Y, Tay J H. The essential role of hydrodynamic shear force in the formation of biofilm and granular sludge[J]. Water Research, 2002, 36 (7): 1653-1665. 被引量:1
  • 8Liu Y, Wang Z W, Tay J H. A unified theory for upscaling aerobic granular sludge sequencing batch reactors[J]. Biotechnology Advances, 2005, 23 (5): 335-344. 被引量:1
  • 9Morales N, Figueroa M, Mosquera-Corral A, et al. Aerobic granular-type biomass development in a continuous stirred tank reactor[J]. Separation and Purification Technology, 2012, 89 (22): 199-205. 被引量:1
  • 10Zhou D D, Liu M Y, Wang J, et al. Granulation of activated sludge in a continuous flow airlift reactor by strong drag force[J]. Biotechnology andBioprocess Engineering, 2013, 18 (2): 289-299. 被引量:1

引证文献3

二级引证文献9

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部