期刊文献+

基于输出系数模型的北京地区农业面源污染负荷估算 被引量:85

Estimation of pollution loads from agricultural nonpoint sources in Beijing region based on export coefficient modeling approach
下载PDF
导出
摘要 农业生产活动产生的面源污染物是环境污染负荷的主要来源之一。利用输出系数模型对北京市农业面源污染负荷进行了估算。结果表明,2006年北京市农业面源污染物总氮和总磷负荷量分别是19565.7×106和2413.1×106g/a。土地利用方式显著影响氮和磷负荷,不同污染源类型对污染负荷贡献的差异较大。不同污染源类型对总氮污染负荷贡献率的大小顺序为农村生活污水及废弃物>耕地>林地>畜禽养殖>园地>牧草地,对总磷负荷贡献率的大小顺序为农村生活污水及废弃物>畜禽养殖>耕地>林地>园地>牧草地。各区县总氮和总磷负荷量和负荷强度的差异较大,其中大兴、顺义、房山、密云和通州的总氮和总磷负荷量较大,而朝阳、丰台、通州、顺义和大兴的总氮和总磷负荷强度较大。农业面源污染物氮和磷分布状况和负荷强度的研究,为北京地区区域规划和农业结构调整提供了科学依据。 Nonpoint source pollutants produced from agricultural production activity is one of the major pollutant sources for environmental pollution.Pollution loads from agricultural nonpoint sources in Beijing City were estimated according to the approach of export coefficient modeling.The results demonstrated that total nitrogen and total phosphorus loads in Beijing City respectively were 19565.7 and 2413.1 Mg a-1 in 2006.Total nitrogen and phosphorus loads was affected by types of land utilization significantly.The contributions to pollution load from various types of pollutant sources were different.The magnitude order of the contribution from various types of pollutant sources was wastewater and garbage from rural residents cultivated land forest land livestock and poultry breeding garden plot grassplot for total nitrogen load,and wastewater and garbage from rural residents livestock and poultry breeding cultivated land forest land garden plot grassplot for total phosphorus load,respectively.The differences among various districts/counties in Beijing about total nitrogen and total phosphorus loads and their load intensities were great.Total nitrogen and total phosphorous loads in Daxing,Shunyi,Fangshan,Miyun,and Tongzhou Districts were bigger,and the load intensities of total nitrogen and total phosphorous in Chaoyang,Fengtai,Tongzhou,Shunyi,and Daxing Districts were higher.The research about the distribution of nitrogen and phosphorous pollutants and their load intensities from agricultural nonpoint sources can provide a foundation on regional planning and agricultural structure adjustment in Beijing region.
出处 《农业工程学报》 EI CAS CSCD 北大核心 2011年第7期7-12,共6页 Transactions of the Chinese Society of Agricultural Engineering
基金 北京市科技计划项目"北京市地下水资源安全评价及污染防控技术研究与示范(D07050601510000)
关键词 估算 农业 污染 结构调整 面源污染 土地利用 污染负荷 污染源类型 estimation agriculture pollution pollution load nonpoint source pollution land use structural adjustment pollution load
  • 相关文献

参考文献28

  • 1Johns P J, Heathwaite A L. Modeling the impact of land use change on water quality in agricultural catchments[J]. Hydrological Processes, 1997, 11(3): 269-286. 被引量:1
  • 2Chung S W, Gassman P W, Kramer L A, et al. Validation of EPIC for two watersheds in southwest Iowa[J]. Journal of Environmental Quality, 1999, 28(3): 971 - 979. 被引量:1
  • 3Baginska B, Milne-Home W, Cornish P S. Modeling nutrient transport in Currency Greek, NSW with AnnAGNPS and PEST[J]. Environmental Modelling and Software, 2003, 18(8-9): 801-808. 被引量:1
  • 4陈欣,郭新波.采用AGNPS模型预测小流域磷素流失的分析[J].农业工程学报,2000,16(5):44-47. 被引量:29
  • 5Young R A, Onstad C A, Bosch D D, et al. AGNPS: A nonpoint-source pollution model for evaluating agricultural watershed[J]. Journal of Soil and Water Conservation, 1989, 44(2): 168- 173. 被引量:1
  • 6Worrall F, Burt T P. The impact of land-use change on water quality at the catchment scale: the use of export coefficient and structural models[J]. J Hydrol. 1999, 221(1/2): 75-90. 被引量:1
  • 7Ierodiaconou D, Laurenson L, Leblanc M, et al. The consequences of land use change on nutrient exports: a regional scale assessment in south-west Victoria, Australia[J] J Environ Manage. 2005.74(4): 305-316. 被引量:1
  • 8龙天渝,梁常德,李继承,刘腊美.基于SLURP模型和输出系数法的三峡库区非点源氮磷负荷预测[J].环境科学学报,2008,28(3):574-581. 被引量:72
  • 9庄永涛.渭河临潼断面以上流域非点源总氮负荷研究[D].西安:西安理工大学硕士学位论文,2002. 被引量:1
  • 10刘瑞民,杨志峰,丁晓雯,沈珍瑶,伍星,刘芳.土地利用/覆盖变化对长江上游非点源污染影响研究[J].环境科学,2006,27(12):2407-2414. 被引量:69

二级参考文献185

共引文献806

同被引文献1052

引证文献85

二级引证文献878

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部