摘要
采用作者等人开发的基于Deform-3D与Pro/Engineer的网格行重构技术,对典型大断面空心铝合金工业型材分流模挤压全过程（包括焊合过程）进行了模拟分析。结果表明,采用某企业的现行模具设计方案,挤压初始阶段,型材两侧焊合面率先产生焊合,中间部位焊合面的焊合相对滞后,导致挤出型材断面的中间位置金属流量不足,同时模芯出现弹性偏移,易造成壁厚超差;挤压稳态阶段,模孔附近型材的最高温度为520℃、焊合室内的静水压力约为A6005铝合金屈服强度的5~10倍、模芯弹性偏移量为0.43 mm,基本满足型材挤出温度、焊合质量及壁厚尺寸公差的要求。
Applying the mesh reconstruction technology based on Deform-3D and Pro/Engineer software,taking the typical large and hollow Al-alloy industry profile as an example,the whole extrusion process（including welding process） was simulated.The results show that,using an enterprise＇s porthole die design,in the beginning of extrusion,the welding of the middle-welding plane is delayed compared with the two side-welding planes,which leads to the shortage of the metal in the middle of the profile cross section as well as the elastic offset of the mandrel which is apt to causing the size deviation of the profile thickness.In the stage of steady extrusion,the highest temperature near the die orifice is about 520℃,the hydrostatic pressure in welding chamber is about 5-10 times than the yield stress of A6005,the mandrel offset is about 0.43mm,that means the extrusion temperature,welding quality and the thickness-size deviation meet the industry requirements.
出处
《锻压技术》
CAS
CSCD
北大核心
2010年第6期128-133,共6页
Forging & Stamping Technology
基金
国家重点基础研究发展计划资助项目(2007CB613703)
材料成形与模具技术国家重点实验室开放课题研究基金(09-01)
关键词
铝合金空心型材
分流模挤压
网格重构
数值模拟
hollow profile of Al-alloy
porthole extrusion
mesh reconstruction
numerical simulation
