摘要
实验研究了部分水解聚丙烯酰胺(HPAM)稀溶液(水溶液)在内径为10.1～325μm石英微管中的高剪切速率(1215～23120 s^(-1))流动.结果表明,聚合物溶液在管径小于100μm微管中的流动具有明显的微尺度效应,实测流速高于由同种溶液在常规管径圆管中的流动规律所预测的流速.实测流速与预测流速之间的偏离程度与管径和剪切速率有关:相同剪切速率下,管径越小,偏离越明显;在小管径微管中,偏离随剪切速率的增加而减小,而当管径超过30.7μm后,偏离不再随剪切速率的变化而改变.
The high shear rate flow（1215～23120s^（-1）） characteristics of the partically hydrolyzed polyacrylamide （HPAM） in silica micro-tubes with diameters in the range of 10.1～325μm were investigated experimentally. It is shown that the effect of the microtule is obvious in microtubes with diameters less than 100μm.The experimental average velocity is higher than expected which is the flow of the same solution in general-sized tubes.In addition,the discrepancy between the experimental and the expected average velocities is influenced by the diameter and the shear rate.Under the same shear rate the smaller the diameter of the microtube is, the more obvious the discrepancy is.In microtubes the discrepancy decreases as the shear rate,however,if the diameters beyond 30.7μm,the discrepancy hardly varies with the shear rate any more.
出处
《力学学报》
EI
CSCD
北大核心
2011年第1期90-96,共7页
Chinese Journal of Theoretical and Applied Mechanics
基金
国家自然科学基金资助项目(50574060)~~
关键词
微尺度流动
衰竭层
表观滑移
聚合物迁移
流变特性
microflow
depleted layer
apparent slippage
polymer migration
rheology behavior
