摘要
油藏注水开采是提高采收率的重要方法，由于热采传递复杂，理论和试验研究存在一定的局限，本文将参考某油田常用射孔枪实物模型建立物理模型，经过合理简化建立数学模型，借助FLUENT模拟软件进行模拟，为描述注热流体驱油过程提供帮助。模拟结果表明，原油的流动性和驱动性较差，粘度越大，流动效果越差。
The injection of hot fluid into oil reservoir is an important means to raise the oil recovery. Due to the complexity of the heat transfer process during the injection of hot fluid, there are some limitations for the theoretical and experimental studies. Referring to an entity model of common perforating guns in oilfield, a physical model is set up. Through reasonable simplification, the mathematical model is established. Then, the process is calculated by using FLUENT software. The results show that the flowability and driving performance is poor. The greater the viscosity ofoil is, the worse the flowing proporty is.
出处
《中国造船》
EI
CSCD
北大核心
2010年第A02期235-240,共6页
Shipbuilding of China
关键词
深水
油藏
传热传质
FLUENT
deep water
reservoir： heat and mass transfer
FLUENT
