摘要
利用固体脉冲Nd:YAG激光对AZ31B变形镁合金的切割工艺进行了研究。结果表明,当平均功率和脉冲宽度相同时,切缝宽度随着脉冲频率的增大而减小;平均功率和脉冲频率相同时,脉冲宽度是影响切缝宽度的主要参数;脉冲频率和脉冲宽度相同时,切缝宽度随着平均功率、峰值功率和单脉冲能量的增大而增加;在相同的平均功率、峰值功率和脉宽比下,脉冲宽度是影响切缝宽度主要参数。脉冲激光切割薄板镁合金时应选择较小脉宽、中等频率和适当的峰值功率的原则。
In this paper, the cutting parameters of AZ31B Magnesium Alloy Plate by using a solid-state pulse Nd..YAG laser was mainly studied. The results show that kerf width decreases with pulse frequency increases under the same average power and pulse width. Keeping average power and pulse frequency constant, pulse width is the primary parameter to influence the kerf width. Kerf width increases in accordance with the changing of average power, peak power and pulse energy as pulse frequency is equal to pulse width. In the same of average power, peak power and duty cycle constant, pulse width is the primary parameter which affects the kerf width. Smaller pulse width, moderate pulse frequency and medium peak power should be used when cutting magnesium alloy by means of pulse laser.
出处
《应用激光》
CSCD
北大核心
2010年第5期381-385,共5页
Applied Laser
基金
山西省自然科学基金资助项目(项目编号:2008011044)
关键词
脉冲YAG激光切割
脉冲宽度
脉冲频率
脉宽比
峰值功率
缝宽
pulse YAG laser cutting
pulse width
pulsed frequency
pulse duration ratio
peak power
kerfs width
