摘要
在普通涤纶纺牵一步法ＦＤＹ设备上，采用合理的干燥工艺可获得结晶充分，含水率稳定在２５μｇ／ｇ以内，粘度波动小于等于０．０１０ｄＬ／ｇ的阳离子染料可染共聚酯（ＣＤＰ）干切片；与同规格普通ＰＥＴＦＤＹ相比，适当调整纺丝温度在２９２～２９５℃，降低侧吹风速度，提高侧吹风温度，降低ＧＲ２与ＧＲ１间拉伸倍数，提高ＧＲ２定型温度，其它卷绕拉伸工艺也作相应的调整，可获得质量优良的ＣＤＰＦＤＹ产品。
Cation\|dyeable dried PET chips can be obtained by reasonable drying process on general PET FDY equipments of spin\|and\|draw one\|step process. The resulted chips remain the water content of less than 25 g/g and viscosity change less than 0010 dL/g. Based on the normal PET FDY of the same sort, CDP FDY with excellent quality can be obtained by appropriately adjusting the spinning temperature in the range of 292￣295, lowering quench air velocity, raising quench air temperature, decreasing draw ratio between GR2 and GR1, increasing GR2 set temperature and adjusting the other related parameters.
出处
《合成纤维工业》
CAS
CSCD
1999年第2期50-52,共3页
China Synthetic Fiber Industry
关键词
阳离子涂料
全拉伸丝
纺拉一步法
聚酯纤维
改性
cationic dyeability fiber
polyethylene terephthalate
fully\|draw yarn
technological process
technology
