期刊文献+

钢拉杆与钢绞线的抗力分项系数研究 被引量:8

Resistance partial factors for high strength steel rods and spiral strands
下载PDF
导出
摘要 由于缺乏足够的试验统计数据,目前对于索结构中拉索构件的设计强度多采用以经验为主的允许应力法确定,或在形式上采用分项系数,但具体数值仍按允许应力法推算,这与当前以概率极限状态法为基础的规范设计体系是不协调的。收集大量的钢拉杆与钢绞线试验数据,通过数理统计得到两种拉索材料的抗力分布模式,考察影响构件抗力的不确定性因素的统计特性;验证拉索结构的荷载效应与外荷载之间存在近似线性关系,通过引入荷载效应比以及荷载、抗力的均值等统计量,将荷载抗力分项系数表达式等价为极限状态方程的形式,采用基于一次二阶矩理论的验算点法对两种拉索进行可靠度分析。最后分别给出适于工程应用的钢拉杆与钢绞线的抗力分项系数,为今后相关规范的修订提供参考。 Due to lack of experimental statistical data, most practical design codes for cables are based on either the empirical ‘Allowable Stress Design (ASD) ' method or such method taking the form of the so-called ‘Load Resistance Factor Design (LRFD)' approach. However, these two cable design methods are not appropriate for the current design codes that should be based on structural reliability analysis. In order to solve this problem, a great deal of statistical data about high strength steel rods and spiral strands have been gained to find out the probability distribution of these two kinds of cable materials, and the uncertain factors that influence structural resistance are analyzed simultaneously. The equation which takes the combination of simple load effects into account with partial factors can be changed into a limit state equation by adopting proportions of load effects, which are proved to have an approximate linear relationship between loads and effects. The partial factors for high strength steel rods and spiral strands are eventually obtained based on the First-Order Second-Moment (FOSM) theory, and they may serve as a reference for the amendment of structural design codes.
机构地区 哈尔滨工业大学
出处 《土木工程学报》 EI CSCD 北大核心 2008年第9期8-13,共6页 China Civil Engineering Journal
基金 国家自然科学基金(50478028) 东南大学混凝土及预应力混凝土结构教育部重点实验室开放课题(2006)资助
关键词 抗力分项系数 钢拉杆 钢绞线 一次二阶矩法 resistance partial factor high strength steel rods spiral strands First-Order Second-Moment (FOSM) theory
  • 相关文献

参考文献6

二级参考文献7

  • 1.GB50068- 2001.建筑结构设计统一标准[S].,.. 被引量:1
  • 2(GB50068--2001).建筑结构可靠度设计统一标准.[S].,.. 被引量:1
  • 3(JTJ027—96).公路斜拉桥设汁规范(试行).[S].,.. 被引量:1
  • 4(DGJ08—97—2002).上海市工程建设规范:膜结构技术规程.[S].,.. 被引量:1
  • 5GB50068-2001.建筑结构可靠度设计统一标准[S].[S].,.. 被引量:178
  • 6JTJ027-96.公路斜拉桥设计规范[S].[S].,.. 被引量:26
  • 7GB50068-2001,Unite criteria for design of building and structure[S]. 被引量:1

共引文献204

同被引文献97

引证文献8

二级引证文献90

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部